@@ -17,6 +17,7 @@ static struct ccu_clk_gate v3s_gates[] = {
[CLK_BUS_MMC0] = GATE(0x060, BIT(8)),
[CLK_BUS_MMC1] = GATE(0x060, BIT(9)),
[CLK_BUS_MMC2] = GATE(0x060, BIT(10)),
+ [CLK_BUS_EMAC] = GATE(0x060, BIT(17)),
[CLK_BUS_SPI0] = GATE(0x060, BIT(20)),
[CLK_BUS_OTG] = GATE(0x060, BIT(24)),
@@ -24,9 +25,11 @@ static struct ccu_clk_gate v3s_gates[] = {
[CLK_BUS_UART1] = GATE(0x06c, BIT(17)),
[CLK_BUS_UART2] = GATE(0x06c, BIT(18)),
- [CLK_SPI0] = GATE(0x0a0, BIT(31)),
+ [CLK_BUS_EPHY] = GATE(0x070, BIT(0)),
- [CLK_USB_PHY0] = GATE(0x0cc, BIT(8)),
+ [CLK_SPI0] = GATE(0x0a0, BIT(31)),
+
+ [CLK_USB_PHY0] = GATE(0x0cc, BIT(8)),
};
static struct ccu_reset v3s_resets[] = {
@@ -35,12 +38,15 @@ static struct ccu_reset v3s_resets[] = {
[RST_BUS_MMC0] = RESET(0x2c0, BIT(8)),
[RST_BUS_MMC1] = RESET(0x2c0, BIT(9)),
[RST_BUS_MMC2] = RESET(0x2c0, BIT(10)),
+ [RST_BUS_EMAC] = RESET(0x2c0, BIT(17)),
[RST_BUS_SPI0] = RESET(0x2c0, BIT(20)),
[RST_BUS_OTG] = RESET(0x2c0, BIT(24)),
[RST_BUS_UART0] = RESET(0x2d8, BIT(16)),
[RST_BUS_UART1] = RESET(0x2d8, BIT(17)),
[RST_BUS_UART2] = RESET(0x2d8, BIT(18)),
+
+ [RST_BUS_EPHY] = RESET(0x2c8, BIT(2)),
};
static const struct ccu_desc v3s_ccu_desc = {
@@ -56,9 +56,11 @@
#define RX_TOTAL_BUFSIZE (CONFIG_ETH_BUFSIZE * CONFIG_RX_DESCR_NUM)
#define H3_EPHY_DEFAULT_VALUE 0x58000
+#define V3S_EPHY_DEFAULT_VALUE 0x38000
#define H3_EPHY_DEFAULT_MASK GENMASK(31, 15)
#define H3_EPHY_ADDR_SHIFT 20
#define REG_PHY_ADDR_MASK GENMASK(4, 0)
+#define H3_EPHY_CLK_SEL BIT(18) /* 1: 24MHz, 0: 25MHz */
#define H3_EPHY_LED_POL BIT(17) /* 1: active low, 0: active high */
#define H3_EPHY_SHUTDOWN BIT(16) /* 1: shutdown, 0: power up */
#define H3_EPHY_SELECT BIT(15) /* 1: internal PHY, 0: external PHY */
@@ -111,6 +113,7 @@ enum emac_variant {
H3_EMAC,
A64_EMAC,
R40_GMAC,
+ V3S_EMAC,
};
struct emac_dma_desc {
@@ -278,10 +281,11 @@ static int sun8i_emac_set_syscon_ephy(struct emac_eth_dev *priv, u32 *reg)
* needs to be configured and powered up before use
*/
*reg &= ~H3_EPHY_DEFAULT_MASK;
- *reg |= H3_EPHY_DEFAULT_VALUE;
+ *reg |= ((priv->variant == V3S_EMAC) ? V3S_EPHY_DEFAULT_VALUE : H3_EPHY_DEFAULT_VALUE);
*reg |= priv->phyaddr << H3_EPHY_ADDR_SHIFT;
*reg &= ~H3_EPHY_SHUTDOWN;
*reg |= H3_EPHY_SELECT;
+ *reg |= H3_EPHY_CLK_SEL;
} else
/* This is to select External Gigabit PHY on
* the boards with H3 SoC.
@@ -310,14 +314,14 @@ static int sun8i_emac_set_syscon(struct sun8i_eth_pdata *pdata,
reg = readl(priv->sysctl_reg + 0x30);
- if (priv->variant == H3_EMAC) {
+ if (priv->variant == H3_EMAC || priv->variant == V3S_EMAC) {
ret = sun8i_emac_set_syscon_ephy(priv, ®);
if (ret)
return ret;
}
reg &= ~(SC_ETCS_MASK | SC_EPIT);
- if (priv->variant == H3_EMAC || priv->variant == A64_EMAC)
+ if (priv->variant == H3_EMAC || priv->variant == V3S_EMAC || priv->variant == A64_EMAC)
reg &= ~SC_RMII_EN;
switch (priv->interface) {
@@ -837,7 +841,7 @@ static int sun8i_emac_eth_probe(struct udevice *dev)
sun8i_mdio_init(dev->name, dev);
priv->bus = miiphy_get_dev_by_name(dev->name);
-
+
return sun8i_phy_init(priv, dev);
}
@@ -981,7 +985,7 @@ static int sun8i_emac_eth_ofdata_to_platdata(struct udevice *dev)
return -EINVAL;
}
- if (priv->variant == H3_EMAC) {
+ if (priv->variant == H3_EMAC || priv->variant == V3S_EMAC) {
ret = sun8i_get_ephy_nodes(priv);
if (ret)
return ret;
@@ -1025,13 +1029,16 @@ static int sun8i_emac_eth_ofdata_to_platdata(struct udevice *dev)
}
static const struct udevice_id sun8i_emac_eth_ids[] = {
- {.compatible = "allwinner,sun8i-h3-emac", .data = (uintptr_t)H3_EMAC },
+ {.compatible = "allwinner,sun8i-h3-emac",
+ .data = (uintptr_t)H3_EMAC },
{.compatible = "allwinner,sun50i-a64-emac",
.data = (uintptr_t)A64_EMAC },
{.compatible = "allwinner,sun8i-a83t-emac",
.data = (uintptr_t)A83T_EMAC },
{.compatible = "allwinner,sun8i-r40-gmac",
.data = (uintptr_t)R40_GMAC },
+ {.compatible = "allwinner,sun8i-v3s-emac",
+ .data = (uintptr_t)V3S_EMAC },
{ }
};
This patch expands the sun8i-emac driver to support the V3s. For this the CLK and RST gates for EMAC and EPHY were added in clk_v3s.c. Signed-off-by: Benedikt-Alexander Mokro? <u-boot at bamkrs.de> --- drivers/clk/sunxi/clk_v3s.c | 10 ++++++++-- drivers/net/sun8i_emac.c | 19 +++++++++++++------ 2 files changed, 21 insertions(+), 8 deletions(-)