@@ -7,24 +7,28 @@
#ifndef __ASM_ARM_ARCH_DWMMC_H
#define __ASM_ARM_ARCH_DWMMC_H
-#define DWMCI_CLKSEL 0x09C
-#define DWMCI_CLKSEL64 0x0a8
-#define DWMCI_SET_SAMPLE_CLK(x) (x)
-#define DWMCI_SET_DRV_CLK(x) ((x) << 16)
-#define DWMCI_SET_DIV_RATIO(x) ((x) << 24)
+#include <linux/bitops.h>
-#define EMMCP_MPSBEGIN0 0x1200
-#define EMMCP_SEND0 0x1204
-#define EMMCP_CTRL0 0x120C
+#define DWMCI_CLKSEL 0x09c
+#define DWMCI_CLKSEL64 0x0a8
+#define DWMCI_SET_SAMPLE_CLK(x) (x)
+#define DWMCI_SET_DRV_CLK(x) ((x) << 16)
+#define DWMCI_SET_DIV_RATIO(x) ((x) << 24)
-#define MPSCTRL_SECURE_READ_BIT (0x1<<7)
-#define MPSCTRL_SECURE_WRITE_BIT (0x1<<6)
-#define MPSCTRL_NON_SECURE_READ_BIT (0x1<<5)
-#define MPSCTRL_NON_SECURE_WRITE_BIT (0x1<<4)
-#define MPSCTRL_USE_FUSE_KEY (0x1<<3)
-#define MPSCTRL_ECB_MODE (0x1<<2)
-#define MPSCTRL_ENCRYPTION (0x1<<1)
-#define MPSCTRL_VALID (0x1<<0)
+/* Protector Register */
+#define DWMCI_EMMCP_BASE 0x1000
+#define EMMCP_MPSBEGIN0 (DWMCI_EMMCP_BASE + 0x0200)
+#define EMMCP_SEND0 (DWMCI_EMMCP_BASE + 0x0204)
+#define EMMCP_CTRL0 (DWMCI_EMMCP_BASE + 0x020c)
+
+#define MPSCTRL_SECURE_READ_BIT BIT(7)
+#define MPSCTRL_SECURE_WRITE_BIT BIT(6)
+#define MPSCTRL_NON_SECURE_READ_BIT BIT(5)
+#define MPSCTRL_NON_SECURE_WRITE_BIT BIT(4)
+#define MPSCTRL_USE_FUSE_KEY BIT(3)
+#define MPSCTRL_ECB_MODE BIT(2)
+#define MPSCTRL_ENCRYPTION BIT(1)
+#define MPSCTRL_VALID BIT(0)
/* CLKSEL Register */
#define DWMCI_DIVRATIO_BIT 24
@@ -45,7 +45,7 @@ struct exynos_dwmmc_variant {
u32 quirks; /* quirk flags - see DWMCI_QUIRK_... */
};
-/* Exynos implmentation specific drver private data */
+/* Exynos implementation specific driver private data */
struct dwmci_exynos_priv_data {
#ifdef CONFIG_DM_MMC
struct dwmci_host host;
@@ -121,10 +121,7 @@ static int exynos_dwmmc_set_sclk(struct dwmci_host *host, unsigned long rate)
return 0;
}
-/*
- * Function used as callback function to initialise the
- * CLKSEL register for every mmc channel.
- */
+/* Configure CLKSEL register with chosen timing values */
static int exynos_dwmci_clksel(struct dwmci_host *host)
{
struct dwmci_exynos_priv_data *priv = exynos_dwmmc_get_priv(host);
@@ -163,7 +160,7 @@ static u8 exynos_dwmmc_get_ciu_div(struct dwmci_host *host)
& DWMCI_DIVRATIO_MASK) + 1;
}
-unsigned int exynos_dwmci_get_clk(struct dwmci_host *host, uint freq)
+static unsigned int exynos_dwmci_get_clk(struct dwmci_host *host, uint freq)
{
unsigned long sclk;
u8 clk_div;
@@ -204,7 +201,6 @@ static void exynos_dwmci_board_init(struct dwmci_host *host)
MPSCTRL_NON_SECURE_WRITE_BIT | MPSCTRL_VALID);
}
- /* Set to timing value at initial time */
if (priv->sdr_timing)
exynos_dwmci_clksel(host);
}
@@ -214,8 +210,8 @@ static int exynos_dwmmc_of_to_plat(struct udevice *dev)
{
struct dwmci_exynos_priv_data *priv = dev_get_priv(dev);
struct dwmci_host *host = &priv->host;
- int err = 0;
u32 div, timing[2];
+ int err;
priv->chip = (struct exynos_dwmmc_variant *)dev_get_driver_data(dev);
@@ -223,9 +219,8 @@ static int exynos_dwmmc_of_to_plat(struct udevice *dev)
const void *blob = gd->fdt_blob;
int node = dev_of_offset(dev);
- /* Extract device id for each mmc channel */
+ /* Obtain device ID for current MMC channel */
host->dev_id = pinmux_decode_periph_id(blob, node);
-
host->dev_index = dev_read_u32_default(dev, "index", host->dev_id);
if (host->dev_index == host->dev_id)
host->dev_index = host->dev_id - PERIPH_ID_SDMMC0;
@@ -241,10 +236,6 @@ static int exynos_dwmmc_of_to_plat(struct udevice *dev)
host->dev_index = 2; /* SD card */
#endif
- /* Get the bus width from the device node (Default is 4bit buswidth) */
- host->buswidth = dev_read_u32_default(dev, "bus-width", 4);
-
- /* Set the base address from the device node */
host->ioaddr = dev_read_addr_ptr(dev);
if (!host->ioaddr) {
printf("DWMMC%d: Can't get base address\n", host->dev_index);
@@ -255,17 +246,17 @@ static int exynos_dwmmc_of_to_plat(struct udevice *dev)
div = priv->chip->div;
else
div = dev_read_u32_default(dev, "samsung,dw-mshc-ciu-div", 0);
+
err = dev_read_u32_array(dev, "samsung,dw-mshc-sdr-timing", timing, 2);
if (err) {
printf("DWMMC%d: Can't get sdr-timings\n", host->dev_index);
return -EINVAL;
}
-
priv->sdr_timing = DWMCI_SET_SAMPLE_CLK(timing[0]) |
DWMCI_SET_DRV_CLK(timing[1]) |
DWMCI_SET_DIV_RATIO(div);
- /* sdr_timing didn't assigned anything, use the default value */
+ /* sdr_timing wasn't set, use the default value */
if (!priv->sdr_timing) {
if (host->dev_index == 0)
priv->sdr_timing = DWMMC_MMC0_SDR_TIMING_VAL;
@@ -284,6 +275,7 @@ static int exynos_dwmmc_of_to_plat(struct udevice *dev)
DWMCI_SET_DIV_RATIO(div);
}
+ host->buswidth = dev_read_u32_default(dev, "bus-width", 4);
host->fifo_depth = dev_read_u32_default(dev, "fifo-depth", 0);
host->bus_hz = dev_read_u32_default(dev, "clock-frequency", 0);
@@ -396,8 +388,8 @@ U_BOOT_DRIVER(exynos_dwmmc_drv) = {
.of_match = exynos_dwmmc_ids,
.of_to_plat = exynos_dwmmc_of_to_plat,
.bind = exynos_dwmmc_bind,
- .ops = &dm_dwmci_ops,
.probe = exynos_dwmmc_probe,
+ .ops = &dm_dwmci_ops,
.priv_auto = sizeof(struct dwmci_exynos_priv_data),
.plat_auto = sizeof(struct exynos_mmc_plat),
};
Fix most of checkpatch warnings and other obvious style issues. No functional change. Signed-off-by: Sam Protsenko <semen.protsenko@linaro.org> --- arch/arm/mach-exynos/include/mach/dwmmc.h | 36 +++++++++++++---------- drivers/mmc/exynos_dw_mmc.c | 26 ++++++---------- 2 files changed, 29 insertions(+), 33 deletions(-)