@@ -12,19 +12,17 @@
#undef UPDATE_SROM
-/* PCI Registers.
- */
-#define PCI_CFDA_PSM 0x43
+/* PCI Registers. */
+#define PCI_CFDA_PSM 0x43
#define CFRV_RN 0x000000f0 /* Revision Number */
#define WAKEUP 0x00 /* Power Saving Wakeup */
#define SLEEP 0x80 /* Power Saving Sleep Mode */
-#define DC2114x_BRK 0x0020 /* CFRV break between DC21142 & DC21143 */
+#define DC2114x_BRK 0x0020 /* CFRV break between DC21142 & DC21143 */
-/* Ethernet chip registers.
- */
+/* Ethernet chip registers. */
#define DE4X5_BMR 0x000 /* Bus Mode Register */
#define DE4X5_TPD 0x008 /* Transmit Poll Demand Reg */
#define DE4X5_RRBA 0x018 /* RX Ring Base Address Reg */
@@ -34,8 +32,7 @@
#define DE4X5_SICR 0x068 /* SIA Connectivity Register */
#define DE4X5_APROM 0x048 /* Ethernet Address PROM */
-/* Register bits.
- */
+/* Register bits. */
#define BMR_SWR 0x00000001 /* Software Reset */
#define STS_TS 0x00700000 /* Transmit Process State */
#define STS_RS 0x000e0000 /* Receive Process State */
@@ -45,8 +42,7 @@
#define OMR_SDP 0x02000000 /* SD Polarity - MUST BE ASSERTED */
#define OMR_PM 0x00000080 /* Pass All Multicast */
-/* Descriptor bits.
- */
+/* Descriptor bits. */
#define R_OWN 0x80000000 /* Own Bit */
#define RD_RER 0x02000000 /* Receive End Of Ring */
#define RD_LS 0x00000100 /* Last Descriptor */
@@ -63,12 +59,12 @@
#define SROM_READ_CMD 6
#define SROM_ERASE_CMD 7
-#define SROM_HWADD 0x0014 /* Hardware Address offset in SROM */
+#define SROM_HWADD 0x0014 /* Hardware Address offset in SROM */
#define SROM_RD 0x00004000 /* Read from Boot ROM */
-#define EE_DATA_WRITE 0x04 /* EEPROM chip data in. */
-#define EE_WRITE_0 0x4801
-#define EE_WRITE_1 0x4805
-#define EE_DATA_READ 0x08 /* EEPROM chip data out. */
+#define EE_DATA_WRITE 0x04 /* EEPROM chip data in. */
+#define EE_WRITE_0 0x4801
+#define EE_WRITE_1 0x4805
+#define EE_DATA_READ 0x08 /* EEPROM chip data out. */
#define SROM_SR 0x00000800 /* Select Serial ROM when set */
#define DT_IN 0x00000004 /* Serial Data In */
@@ -79,13 +75,13 @@
#define RESET_DE4X5(dev) {\
int i;\
- i=INL(dev, DE4X5_BMR);\
+ i = INL(dev, DE4X5_BMR);\
udelay(1000);\
OUTL(dev, i | BMR_SWR, DE4X5_BMR);\
udelay(1000);\
OUTL(dev, i, DE4X5_BMR);\
udelay(1000);\
- for (i=0;i<5;i++) {INL(dev, DE4X5_BMR); udelay(10000);}\
+ for (i = 0; i < 5; i++) {INL(dev, DE4X5_BMR); udelay(10000); } \
udelay(1000);\
}
@@ -99,7 +95,7 @@
#define STOP_DE4X5(dev) {\
s32 omr; \
omr = INL(dev, DE4X5_OMR);\
- omr &= ~(OMR_ST|OMR_SR);\
+ omr &= ~(OMR_ST | OMR_SR);\
OUTL(dev, omr, DE4X5_OMR); /* Disable the TX and/or RX */ \
}
@@ -118,30 +114,34 @@ struct de4x5_desc {
u32 next;
};
-static struct de4x5_desc rx_ring[NUM_RX_DESC] __attribute__ ((aligned(32))); /* RX descriptor ring */
-static struct de4x5_desc tx_ring[NUM_TX_DESC] __attribute__ ((aligned(32))); /* TX descriptor ring */
-static int rx_new; /* RX descriptor ring pointer */
-static int tx_new; /* TX descriptor ring pointer */
-
-static char rxRingSize;
-static char txRingSize;
-
-static void sendto_srom(struct eth_device* dev, u_int command, u_long addr);
-static int getfrom_srom(struct eth_device* dev, u_long addr);
-static int do_eeprom_cmd(struct eth_device *dev, u_long ioaddr,int cmd,int cmd_len);
-static int do_read_eeprom(struct eth_device *dev,u_long ioaddr,int location,int addr_len);
+/* RX and TX descriptor ring */
+static struct de4x5_desc rx_ring[NUM_RX_DESC] __aligned(32);
+static struct de4x5_desc tx_ring[NUM_TX_DESC] __aligned(32);
+static int rx_new; /* RX descriptor ring pointer */
+static int tx_new; /* TX descriptor ring pointer */
+
+static char rx_ring_size;
+static char tx_ring_size;
+
+static void sendto_srom(struct eth_device *dev, u_int command, u_long addr);
+static int getfrom_srom(struct eth_device *dev, u_long addr);
+static int do_eeprom_cmd(struct eth_device *dev, u_long ioaddr,
+ int cmd, int cmd_len);
+static int do_read_eeprom(struct eth_device *dev, u_long ioaddr,
+ int location, int addr_len);
#ifdef UPDATE_SROM
-static int write_srom(struct eth_device *dev, u_long ioaddr, int index, int new_value);
+static int write_srom(struct eth_device *dev, u_long ioaddr,
+ int index, int new_value);
static void update_srom(struct eth_device *dev, bd_t *bis);
#endif
static int read_srom(struct eth_device *dev, u_long ioaddr, int index);
-static void read_hw_addr(struct eth_device* dev, bd_t * bis);
-static void send_setup_frame(struct eth_device* dev, bd_t * bis);
+static void read_hw_addr(struct eth_device *dev, bd_t *bis);
+static void send_setup_frame(struct eth_device *dev, bd_t *bis);
-static int dc21x4x_init(struct eth_device* dev, bd_t* bis);
+static int dc21x4x_init(struct eth_device *dev, bd_t *bis);
static int dc21x4x_send(struct eth_device *dev, void *packet, int length);
-static int dc21x4x_recv(struct eth_device* dev);
-static void dc21x4x_halt(struct eth_device* dev);
+static int dc21x4x_recv(struct eth_device *dev);
+static void dc21x4x_halt(struct eth_device *dev);
#if defined(CONFIG_E500)
#define phys_to_bus(a) (a)
@@ -149,12 +149,12 @@ static void dc21x4x_halt(struct eth_device* dev);
#define phys_to_bus(a) pci_phys_to_mem((pci_dev_t)dev->priv, a)
#endif
-static int INL(struct eth_device* dev, u_long addr)
+static int INL(struct eth_device *dev, u_long addr)
{
return le32_to_cpu(*(volatile u_long *)(addr + dev->iobase));
}
-static void OUTL(struct eth_device* dev, int command, u_long addr)
+static void OUTL(struct eth_device *dev, int command, u_long addr)
{
*(volatile u_long *)(addr + dev->iobase) = cpu_to_le32(command);
}
@@ -281,12 +281,12 @@ static int dc21x4x_init(struct eth_device *dev, bd_t *bis)
tx_ring[i].next = 0;
}
- rxRingSize = NUM_RX_DESC;
- txRingSize = NUM_TX_DESC;
+ rx_ring_size = NUM_RX_DESC;
+ tx_ring_size = NUM_TX_DESC;
/* Write the end of list marker to the descriptor lists. */
- rx_ring[rxRingSize - 1].des1 |= cpu_to_le32(RD_RER);
- tx_ring[txRingSize - 1].des1 |= cpu_to_le32(TD_TER);
+ rx_ring[rx_ring_size - 1].des1 |= cpu_to_le32(RD_RER);
+ tx_ring[tx_ring_size - 1].des1 |= cpu_to_le32(TD_TER);
/* Tell the adapter where the TX/RX rings are located. */
OUTL(dev, phys_to_bus((u32)&rx_ring), DE4X5_RRBA);
@@ -380,7 +380,7 @@ static int dc21x4x_recv(struct eth_device *dev)
}
/* Update entry information. */
- rx_new = (rx_new + 1) % rxRingSize;
+ rx_new = (rx_new + 1) % rx_ring_size;
}
return length;
Clean up the remaining driver code, macro space alignment, function declaration indent, replace __attribute__((aligned(32))) with plain __aligned(32). No functional change. Signed-off-by: Marek Vasut <marek.vasut+renesas at gmail.com> Cc: Joe Hershberger <joe.hershberger at ni.com> --- drivers/net/dc2114x.c | 86 +++++++++++++++++++++---------------------- 1 file changed, 43 insertions(+), 43 deletions(-)