From patchwork Tue Apr 7 09:26:51 2020 Content-Type: text/plain; charset="utf-8" MIME-Version: 1.0 Content-Transfer-Encoding: 7bit X-Patchwork-Submitter: Jagan Teki X-Patchwork-Id: 237308 List-Id: U-Boot discussion From: jagan at amarulasolutions.com (Jagan Teki) Date: Tue, 7 Apr 2020 14:56:51 +0530 Subject: [PATCH 2/2] sifive: fu540: Add U-Boot proper sector start In-Reply-To: <20200407092651.9636-1-jagan@amarulasolutions.com> References: <20200407092651.9636-1-jagan@amarulasolutions.com> Message-ID: <20200407092651.9636-2-jagan@amarulasolutions.com> Add U-Boot proper sector start offset for SiFive FU540. This value is based on the partition layout supported by SiFive FU540. u-boot.itb need to write on this specific offset so-that the SPL will retrieve it from here and load. Signed-off-by: Jagan Teki --- Note: On top of https://patchwork.ozlabs.org/cover/1263480/ common/spl/Kconfig | 3 ++- 1 file changed, 2 insertions(+), 1 deletion(-) diff --git a/common/spl/Kconfig b/common/spl/Kconfig index 07eee56219..4c36864602 100644 --- a/common/spl/Kconfig +++ b/common/spl/Kconfig @@ -308,7 +308,7 @@ config SYS_MMCSD_RAW_MODE_U_BOOT_USE_SECTOR ARCH_MX6 || ARCH_MX7 || \ ARCH_ROCKCHIP || ARCH_MVEBU || ARCH_SOCFPGA || \ ARCH_AT91 || ARCH_ZYNQ || ARCH_KEYSTONE || OMAP34XX || \ - OMAP44XX || OMAP54XX || AM33XX || AM43XX + OMAP44XX || OMAP54XX || AM33XX || AM43XX || TARGET_SIFIVE_FU540 help Use sector number for specifying U-Boot location on MMC/SD in raw mode. @@ -325,6 +325,7 @@ config SYS_MMCSD_RAW_MODE_U_BOOT_SECTOR default 0x300 if ARCH_ZYNQ || ARCH_KEYSTONE || OMAP34XX || OMAP44XX || \ OMAP54XX || AM33XX || AM43XX || ARCH_K3 default 0x4000 if ARCH_ROCKCHIP + default 0x1000 if TARGET_SIFIVE_FU540 help Address on the MMC to load U-Boot from, when the MMC is being used in raw mode. Units: MMC sectors (1 sector = 512 bytes).