@@ -15,6 +15,8 @@
#include <asm/io.h>
#include <spl.h>
#include <asm/arch/sys_proto.h>
+#include <dm.h>
+#include <dm/uclass-internal.h>
#include "../common/board_detect.h"
@@ -343,5 +345,29 @@ int board_late_init(void)
void spl_board_init(void)
{
+#if defined(CONFIG_ESM_K3) || defined(CONFIG_ESM_PMIC)
+ struct udevice *dev;
+ int ret;
+#endif
+
probe_daughtercards();
+
+#ifdef CONFIG_ESM_K3
+ if (board_ti_k3_is("J721EX-PM2-SOM")) {
+ ret = uclass_get_device_by_driver(UCLASS_MISC,
+ DM_GET_DRIVER(k3_esm), &dev);
+ if (ret)
+ printf("ESM init failed: %d\n", ret);
+ }
+#endif
+
+#ifdef CONFIG_ESM_PMIC
+ if (board_ti_k3_is("J721EX-PM2-SOM")) {
+ ret = uclass_get_device_by_driver(UCLASS_MISC,
+ DM_GET_DRIVER(pmic_esm),
+ &dev);
+ if (ret)
+ printf("ESM PMIC init failed: %d\n", ret);
+ }
+#endif
}
Initialize both ESM and ESM_PMIC support if available for the board. If support is not available for either, a warning is printed out. ESM signals are only properly routed on PM2 version of the J721E SOM, so only probe the drivers on this device. Signed-off-by: Tero Kristo <t-kristo at ti.com> --- board/ti/j721e/evm.c | 26 ++++++++++++++++++++++++++ 1 file changed, 26 insertions(+)