From patchwork Sun Feb 9 11:05:57 2020 Content-Type: text/plain; charset="utf-8" MIME-Version: 1.0 Content-Transfer-Encoding: 7bit X-Patchwork-Submitter: Anand Moon X-Patchwork-Id: 236073 List-Id: U-Boot discussion From: linux.amoon at gmail.com (Anand Moon) Date: Sun, 9 Feb 2020 11:05:57 +0000 Subject: [PATCHv6 5/5] arm: dts: s400: Move common nodes to the -u-boot.dtsi In-Reply-To: <20200209110557.1996-1-linux.amoon@gmail.com> References: <20200209110557.1996-1-linux.amoon@gmail.com> Message-ID: <20200209110557.1996-6-linux.amoon@gmail.com> Move u-boot specific common nodes in the dts files to meson-axg-s400-u-boot.dtsi. This allows us to keep the basic dts[i] files up-to-date with the ones in kernel, but at the same time allowing the u-boot to add its own properties to the existing nodes. Also add missing mmc alias to dts nodes to avoid below debug warning. mmc_bind: alias ret=-2, devnum=-1 mmc_bind: alias ret=-2, devnum=-1 Signed-off-by: Anand Moon --- no changes from previous changes --- arch/arm/dts/meson-axg-s400-u-boot.dtsi | 16 ++++++++++++++++ arch/arm/dts/meson-axg-s400.dts | 9 --------- 2 files changed, 16 insertions(+), 9 deletions(-) diff --git a/arch/arm/dts/meson-axg-s400-u-boot.dtsi b/arch/arm/dts/meson-axg-s400-u-boot.dtsi index c46eb3f38d..74241e9fcd 100644 --- a/arch/arm/dts/meson-axg-s400-u-boot.dtsi +++ b/arch/arm/dts/meson-axg-s400-u-boot.dtsi @@ -2,6 +2,22 @@ /* * Copyright (c) 2017 Amlogic, Inc. All rights reserved. */ +/ { + soc { + u-boot,dm-pre-reloc; + }; + + aliases { + serial0 = &uart_AO; + serial1 = &uart_A; + mmc1 = &sd_emmc_b; + mmc2 = &sd_emmc_c; + }; + + chosen { + stdout-path = "serial0:115200n8"; + }; +}; /* wifi module */ &sd_emmc_b { diff --git a/arch/arm/dts/meson-axg-s400.dts b/arch/arm/dts/meson-axg-s400.dts index 18778ada7b..feb84255ad 100644 --- a/arch/arm/dts/meson-axg-s400.dts +++ b/arch/arm/dts/meson-axg-s400.dts @@ -55,11 +55,6 @@ }; }; - aliases { - serial0 = &uart_AO; - serial1 = &uart_A; - }; - linein: audio-codec at 0 { #sound-dai-cells = <0>; compatible = "everest,es7241"; @@ -100,10 +95,6 @@ reset-gpios = <&gpio BOOT_9 GPIO_ACTIVE_LOW>; }; - chosen { - stdout-path = "serial0:115200n8"; - }; - memory at 0 { device_type = "memory"; reg = <0x0 0x0 0x0 0x40000000>;