From patchwork Sun Jan 19 07:52:47 2020 Content-Type: text/plain; charset="utf-8" MIME-Version: 1.0 Content-Transfer-Encoding: 7bit X-Patchwork-Submitter: Joel Johnson X-Patchwork-Id: 239763 List-Id: U-Boot discussion From: mrjoel at lixil.net (Joel Johnson) Date: Sun, 19 Jan 2020 00:52:47 -0700 Subject: [PATCH v2 08/10] arm: mvebu: enable working default boot support In-Reply-To: <20200119075249.32226-1-mrjoel@lixil.net> References: <20200119075249.32226-1-mrjoel@lixil.net> Message-ID: <20200119075249.32226-9-mrjoel@lixil.net> With the move to driver model usage, ensure that the required driver support for SPI and MMC booting is available in SPL. Tested on SolidRun ClearFog devices. Signed-off-by: Joel Johnson --- v2 changes: - change "select" for ENV_IS_IN_X to "imply" to allow disabling the default env location and configuring a different one if desired - remove SPL_DM_GPIO from defconfig, only include if needed for MMC booting --- arch/arm/mach-mvebu/Kconfig | 10 ++++++++++ configs/clearfog_defconfig | 1 - 2 files changed, 10 insertions(+), 1 deletion(-) diff --git a/arch/arm/mach-mvebu/Kconfig b/arch/arm/mach-mvebu/Kconfig index 161dee937f..32191e7157 100644 --- a/arch/arm/mach-mvebu/Kconfig +++ b/arch/arm/mach-mvebu/Kconfig @@ -235,9 +235,19 @@ choice config MVEBU_SPL_BOOT_DEVICE_SPI bool "SPI NOR flash" + imply ENV_IS_IN_SPI_FLASH + select SPL_DM_SPI + select SPL_MTD_SUPPORT + select SPL_SPI_FLASH_SUPPORT + select SPL_SPI_LOAD + select SPL_SPI_SUPPORT config MVEBU_SPL_BOOT_DEVICE_MMC bool "SDIO/MMC card" + imply ENV_IS_IN_MMC + # GPIO required for SD card presence detection line + select SPL_DM_GPIO + select SPL_DM_MMC select SPL_LIBDISK_SUPPORT config MVEBU_SPL_BOOT_DEVICE_SATA diff --git a/configs/clearfog_defconfig b/configs/clearfog_defconfig index e932f9c195..24f0b557be 100644 --- a/configs/clearfog_defconfig +++ b/configs/clearfog_defconfig @@ -28,7 +28,6 @@ CONFIG_SYS_CONSOLE_INFO_QUIET=y # CONFIG_DISPLAY_BOARDINFO is not set CONFIG_DISPLAY_BOARDINFO_LATE=y CONFIG_SYS_MMCSD_RAW_MODE_U_BOOT_DATA_PART_OFFSET=0x1 -CONFIG_SPL_DM_GPIO=y CONFIG_SPL_I2C_SUPPORT=y CONFIG_CMD_SYS_EEPROM=y CONFIG_SPL_CMD_SYS_EEPROM=y