From patchwork Fri Jan 10 00:14:15 2020 Content-Type: text/plain; charset="utf-8" MIME-Version: 1.0 Content-Transfer-Encoding: 7bit X-Patchwork-Submitter: Marek Vasut X-Patchwork-Id: 239350 List-Id: U-Boot discussion From: marex at denx.de (Marek Vasut) Date: Fri, 10 Jan 2020 01:14:15 +0100 Subject: [PATCH 1/3] mtd: rawnand: denali-spl: Add missing hardware init Message-ID: <20200110001417.82917-1-marex@denx.de> While the Denali NAND is initialized by the BootROM in SPL, there are still a couple of settings which are missing. These can trigger subtle corruption of the data read out of the NAND. Fill these settings in just like they are filled in by the full Denali NAND driver in denali_hw_init(). Signed-off-by: Marek Vasut Cc: Masahiro Yamada --- drivers/mtd/nand/raw/denali_spl.c | 7 +++++++ 1 file changed, 7 insertions(+) diff --git a/drivers/mtd/nand/raw/denali_spl.c b/drivers/mtd/nand/raw/denali_spl.c index dbaba3cab2..b8b29812aa 100644 --- a/drivers/mtd/nand/raw/denali_spl.c +++ b/drivers/mtd/nand/raw/denali_spl.c @@ -173,6 +173,13 @@ void nand_init(void) page_size = readl(denali_flash_reg + DEVICE_MAIN_AREA_SIZE); oob_size = readl(denali_flash_reg + DEVICE_SPARE_AREA_SIZE); pages_per_block = readl(denali_flash_reg + PAGES_PER_BLOCK); + + /* Do as denali_hw_init() does. */ + writel(CONFIG_NAND_DENALI_SPARE_AREA_SKIP_BYTES, + denali_flash_reg + SPARE_AREA_SKIP_BYTES); + writel(0x0F, denali_flash_reg + RB_PIN_ENABLED); + writel(CHIP_EN_DONT_CARE__FLAG, denali_flash_reg + CHIP_ENABLE_DONT_CARE); + writel(0xffff, denali_flash_reg + SPARE_AREA_MARKER); } int nand_spl_load_image(uint32_t offs, unsigned int size, void *dst)