From patchwork Sat Mar 14 12:53:56 2020 Content-Type: text/plain; charset="utf-8" MIME-Version: 1.0 Content-Transfer-Encoding: 7bit X-Patchwork-Submitter: Kuldeep Singh X-Patchwork-Id: 243642 List-Id: U-Boot discussion From: kuldeep.singh at nxp.com (Kuldeep Singh) Date: Sat, 14 Mar 2020 18:23:56 +0530 Subject: [Patch v3 3/3] arm: dts: lx2160a: Use flexspi in octal I/O mode In-Reply-To: <1584190436-8772-1-git-send-email-kuldeep.singh@nxp.com> References: <1584190436-8772-1-git-send-email-kuldeep.singh@nxp.com> Message-ID: <1584190436-8772-4-git-send-email-kuldeep.singh@nxp.com> Configure RX and TX bus-width values to use flexspi in octal I/O mode. If bus-widths are not specified, then single I/O mode is set by default. Signed-off-by: Kuldeep Singh --- v3: Reword commit message. v2: No change. arch/arm/dts/fsl-lx2160a-qds.dts | 2 ++ arch/arm/dts/fsl-lx2160a-rdb.dts | 4 ++++ 2 files changed, 6 insertions(+) diff --git a/arch/arm/dts/fsl-lx2160a-qds.dts b/arch/arm/dts/fsl-lx2160a-qds.dts index 33bedae..592fd59 100644 --- a/arch/arm/dts/fsl-lx2160a-qds.dts +++ b/arch/arm/dts/fsl-lx2160a-qds.dts @@ -58,6 +58,8 @@ compatible = "jedec,spi-nor"; spi-max-frequency = <50000000>; reg = <0>; + spi-rx-bus-width = <8>; + spi-tx-bus-width = <1>; }; }; diff --git a/arch/arm/dts/fsl-lx2160a-rdb.dts b/arch/arm/dts/fsl-lx2160a-rdb.dts index e542c69..87617ca 100644 --- a/arch/arm/dts/fsl-lx2160a-rdb.dts +++ b/arch/arm/dts/fsl-lx2160a-rdb.dts @@ -39,6 +39,8 @@ compatible = "jedec,spi-nor"; spi-max-frequency = <50000000>; reg = <0>; + spi-rx-bus-width = <8>; + spi-tx-bus-width = <1>; }; mt35xu512aba1: flash at 1 { @@ -47,6 +49,8 @@ compatible = "jedec,spi-nor"; spi-max-frequency = <50000000>; reg = <1>; + spi-rx-bus-width = <8>; + spi-tx-bus-width = <1>; }; };