@@ -38,6 +38,7 @@ CONFIG_FSL_CAAM=y
CONFIG_DM_MMC=y
CONFIG_FSL_ESDHC=y
# CONFIG_SPI_FLASH_BAR is not set
+CONFIG_SPI_FLASH_SPANSION=y
# CONFIG_SPI_FLASH_USE_4K_SECTORS is not set
CONFIG_PHYLIB=y
CONFIG_E1000=y
@@ -54,6 +54,7 @@ CONFIG_FSL_CAAM=y
CONFIG_DM_MMC=y
CONFIG_FSL_ESDHC=y
# CONFIG_SPI_FLASH_BAR is not set
+CONFIG_SPI_FLASH_SPANSION=y
# CONFIG_SPI_FLASH_USE_4K_SECTORS is not set
CONFIG_PHYLIB=y
CONFIG_E1000=y
@@ -43,6 +43,7 @@ CONFIG_SYS_FLASH_USE_BUFFER_WRITE=y
CONFIG_SYS_FLASH_CFI=y
CONFIG_MTD_RAW_NAND=y
CONFIG_SF_DEFAULT_BUS=1
+CONFIG_SPI_FLASH_SPANSION=y
CONFIG_PHYLIB=y
CONFIG_E1000=y
CONFIG_FMAN_ENET=y
@@ -53,6 +53,7 @@ CONFIG_SYS_FLASH_CFI=y
CONFIG_MTD_RAW_NAND=y
CONFIG_SF_DEFAULT_BUS=1
# CONFIG_SPI_FLASH_BAR is not set
+CONFIG_SPI_FLASH_SPANSION=y
CONFIG_PHYLIB=y
CONFIG_E1000=y
CONFIG_FMAN_ENET=y
@@ -34,6 +34,7 @@ CONFIG_FSL_ESDHC=y
CONFIG_MTD=y
CONFIG_MTD_RAW_NAND=y
# CONFIG_SPI_FLASH_BAR is not set
+CONFIG_SPI_FLASH_SPANSION=y
# CONFIG_SPI_FLASH_USE_4K_SECTORS is not set
CONFIG_PHYLIB=y
CONFIG_PHY_AQUANTIA=y
@@ -37,6 +37,7 @@ CONFIG_FSL_ESDHC=y
CONFIG_MTD=y
CONFIG_MTD_RAW_NAND=y
# CONFIG_SPI_FLASH_BAR is not set
+CONFIG_SPI_FLASH_SPANSION=y
# CONFIG_SPI_FLASH_USE_4K_SECTORS is not set
CONFIG_PHYLIB=y
CONFIG_PHY_AQUANTIA=y
@@ -34,6 +34,7 @@ CONFIG_FSL_ESDHC=y
CONFIG_MTD=y
CONFIG_MTD_RAW_NAND=y
# CONFIG_SPI_FLASH_BAR is not set
+CONFIG_SPI_FLASH_SPANSION=y
# CONFIG_SPI_FLASH_USE_4K_SECTORS is not set
CONFIG_PHYLIB=y
CONFIG_PHY_AQUANTIA=y
@@ -39,6 +39,7 @@ CONFIG_FSL_ESDHC=y
CONFIG_MTD=y
CONFIG_MTD_RAW_NAND=y
# CONFIG_SPI_FLASH_BAR is not set
+CONFIG_SPI_FLASH_SPANSION=y
# CONFIG_SPI_FLASH_USE_4K_SECTORS is not set
CONFIG_PHYLIB=y
CONFIG_PHY_AQUANTIA=y
@@ -41,14 +41,6 @@ unsigned long get_board_ddr_clk(void);
#define CONFIG_SPI_FLASH_EON /* cs2 */
#endif
-/* QSPI */
-#if defined(CONFIG_TFABOOT) || \
- defined(CONFIG_QSPI_BOOT) || defined(CONFIG_SD_BOOT_QSPI)
-#ifdef CONFIG_FSL_QSPI
-#define CONFIG_SPI_FLASH_SPANSION
-#endif
-#endif
-
#ifdef CONFIG_SYS_DPAA_FMAN
#define CONFIG_PHY_VITESSE
#define CONFIG_PHY_REALTEK
@@ -180,13 +180,6 @@
#endif
-/* QSPI device */
-#ifndef SPL_NO_QSPI
-#ifdef CONFIG_FSL_QSPI
-#define CONFIG_SPI_FLASH_SPANSION
-#endif
-#endif
-
#ifndef SPL_NO_MISC
#undef CONFIG_BOOTCOMMAND
#ifdef CONFIG_TFABOOT
Enable CONFIG_SPI_FLASH_SPANSION in defconfigs of LS1046ARDB and LS1046AQDS which have two spansion flases i.e s25fs512s each of size 64M. Signed-off-by: Kuldeep Singh <kuldeep.singh at nxp.com> --- Depends on https://patchwork.ozlabs.org/patch/1219462/ Depends on https://patchwork.ozlabs.org/patch/1208299/ v4: No change v3: No change v2: No change configs/ls1046aqds_qspi_defconfig | 1 + configs/ls1046aqds_sdcard_qspi_defconfig | 1 + configs/ls1046aqds_tfa_SECURE_BOOT_defconfig | 1 + configs/ls1046aqds_tfa_defconfig | 1 + configs/ls1046ardb_qspi_SECURE_BOOT_defconfig | 1 + configs/ls1046ardb_qspi_defconfig | 1 + configs/ls1046ardb_tfa_SECURE_BOOT_defconfig | 1 + configs/ls1046ardb_tfa_defconfig | 1 + include/configs/ls1046aqds.h | 8 -------- include/configs/ls1046ardb.h | 7 ------- 10 files changed, 8 insertions(+), 15 deletions(-)