@@ -205,7 +205,7 @@ u32 get_board_rev(void)
*/
int ft_board_setup(void *blob, bd_t *bd)
{
- struct node_info nodes[] = {
+ static const struct node_info nodes[] = {
{ "physmap-flash.0", MTD_DEV_TYPE_NOR, }, /* NOR flash */
{ "mxc_nand", MTD_DEV_TYPE_NAND, }, /* NAND flash */
};
@@ -519,7 +519,7 @@ int cm_fx6_setup_ecspi(void) { return 0; }
#ifdef CONFIG_OF_BOARD_SETUP
#define USDHC3_PATH "/soc/aips-bus@02100000/usdhc@02198000/"
-struct node_info nodes[] = {
+static const struct node_info nodes[] = {
/*
* Both entries target the same flash chip. The st,m25p compatible
* is used in the vendor device trees, while upstream uses (the
@@ -53,7 +53,7 @@ int checkboard(void)
#if defined(CONFIG_OF_BOARD_SETUP)
#ifdef CONFIG_FDT_FIXUP_PARTITIONS
-struct node_info nodes[] = {
+static const struct node_info nodes[] = {
{ "fsl,ifc-nand", MTD_DEV_TYPE_NAND, },
};
#endif
@@ -357,7 +357,7 @@ void fdt_del_node_compat(void *blob, const char *compatible)
#if defined(CONFIG_OF_BOARD_SETUP)
#ifdef CONFIG_FDT_FIXUP_PARTITIONS
-struct node_info nodes[] = {
+static const struct node_info nodes[] = {
{ "cfi-flash", MTD_DEV_TYPE_NOR, },
{ "fsl,ifc-nand", MTD_DEV_TYPE_NAND, },
};
@@ -1114,7 +1114,7 @@ int ft_board_setup(void *blob, bd_t *bd)
{
struct ventana_board_info *info = &ventana_info;
struct ventana_eeprom_config *cfg;
- struct node_info nodes[] = {
+ static const struct node_info nodes[] = {
{ "sst,w25q256", MTD_DEV_TYPE_NOR, }, /* SPI flash */
{ "fsl,imx6q-gpmi-nand", MTD_DEV_TYPE_NAND, }, /* NAND flash */
};
@@ -211,7 +211,7 @@ int board_late_init(void)
int ft_board_setup(void *blob, bd_t *bd)
{
#ifdef CONFIG_FDT_FIXUP_PARTITIONS
- static struct node_info nodes[] = {
+ static const struct node_info nodes[] = {
{ "ti,omap2-nand", MTD_DEV_TYPE_NAND, },
};
@@ -157,7 +157,7 @@ static int ft_enable_by_compatible(void *blob, char *compat, int enable)
int ft_board_setup(void *blob, bd_t *bd)
{
#ifdef CONFIG_FDT_FIXUP_PARTITIONS
- static struct node_info nodes[] = {
+ static const struct node_info nodes[] = {
{ "ti,omap2-nand", MTD_DEV_TYPE_NAND, },
{ "ti,omap2-onenand", MTD_DEV_TYPE_ONENAND, },
};
@@ -408,7 +408,7 @@ int checkboard(void)
int ft_board_setup(void *blob, bd_t *bd)
{
#if defined(CONFIG_FDT_FIXUP_PARTITIONS)
- static struct node_info nodes[] = {
+ static const struct node_info nodes[] = {
{ "fsl,imx7d-gpmi-nand", MTD_DEV_TYPE_NAND, }, /* NAND flash */
};
@@ -580,7 +580,7 @@ int ft_board_setup(void *blob, bd_t *bd)
{
int ret = 0;
#ifdef CONFIG_FDT_FIXUP_PARTITIONS
- static struct node_info nodes[] = {
+ static const struct node_info nodes[] = {
{ "fsl,vf610-nfc", MTD_DEV_TYPE_NAND, }, /* NAND flash */
};
Add 'const' (also 'static' in some places) to struct node_info arrays to save memory footprint. Signed-off-by: Masahiro Yamada <yamada.masahiro@socionext.com> --- board/CarMediaLab/flea3/flea3.c | 2 +- board/compulab/cm_fx6/cm_fx6.c | 2 +- board/freescale/bsc9131rdb/bsc9131rdb.c | 2 +- board/freescale/bsc9132qds/bsc9132qds.c | 2 +- board/gateworks/gw_ventana/gw_ventana.c | 2 +- board/isee/igep003x/board.c | 2 +- board/isee/igep00x0/igep00x0.c | 2 +- board/toradex/colibri_imx7/colibri_imx7.c | 2 +- board/toradex/colibri_vf/colibri_vf.c | 2 +- 9 files changed, 9 insertions(+), 9 deletions(-)