mbox series

[v3,0/3] Support SDMA mode on RPI4 target - 32bit

Message ID 20200324225859.8462-1-jh80.chung@samsung.com
Headers show
Series Support SDMA mode on RPI4 target - 32bit | expand

Message

Jaehoon Chung March 24, 2020, 10:58 p.m. UTC 
RPI4's SDHCI controller is supported SDMA mode. (Checked on kernel side)
But It doesn't use on u-boot side. Then it's too slow about read/write performance.
This patchset is supported SDMA mode on RPI4 target(32bit).
- I didn't test on RPI4 64bit.

Read/write time about 8MB file
Before
- Read : 1.472 seconds
- Write : 4.690 seconds
After
- Read : 0.359 seconds
- Write : 0.574 seconds

This patch is based on my RFC's patches.RPI4's SDHCI controller is supported SDMA mode. (Checked on kernel side)
But It doesn't use on u-boot side. Then it's too slow about read/write performance.
This patchset is supported SDMA mode on RPI4 target(32bit).
- I didn't test on RPI4 64bit.

Read/write time about 8MB file
Before
- Read : 1.472 seconds
- Write : 4.690 seconds
After
- Read : 0.359 seconds
- Write : 0.574 seconds

Changelog on V3
- Rebased on latest u-boot-mmc

Changelog on V2
- Keep printf message instead of debug
- Add Peng's Reviewed-by tag

Jaehoon Chung (3):
  mmc: sdhci: use phys2bus macro when dma address is accessed
  mmc: sdhci: not return error when SDMA is not supported
  configs: rpi_4_32b_defconfig: enable SDHCI_SDMA config

 configs/rpi_4_32b_defconfig |  1 +
 drivers/mmc/sdhci.c         | 13 +++++++------
 2 files changed, 8 insertions(+), 6 deletions(-)