diff mbox series

[4.9,32/80] iio: xilinx-xadc: Fix sequencer configuration for aux channels in simultaneous mode

Message ID 20200501131524.521873316@linuxfoundation.org
State Superseded
Headers show
Series None | expand

Commit Message

Greg KH May 1, 2020, 1:21 p.m. UTC 
From: Lars-Peter Clausen <lars@metafoo.de>

commit 8bef455c8b1694547ee59e8b1939205ed9d901a6 upstream.

The XADC has two internal ADCs. Depending on the mode it is operating in
either one or both of them are used. The device manual calls this
continuous (one ADC) and simultaneous (both ADCs) mode.

The meaning of the sequencing register for the aux channels changes
depending on the mode.

In continuous mode each bit corresponds to one of the 16 aux channels. And
the single ADC will convert them one by one in order.

In simultaneous mode the aux channels are split into two groups the first 8
channels are assigned to the first ADC and the other 8 channels to the
second ADC. The upper 8 bits of the sequencing register are unused and the
lower 8 bits control both ADCs. This means a bit needs to be set if either
the corresponding channel from the first group or the second group (or
both) are set.

Currently the driver does not have the special handling required for
simultaneous mode. Add it.

Signed-off-by: Lars-Peter Clausen <lars@metafoo.de>
Fixes: bdc8cda1d010 ("iio:adc: Add Xilinx XADC driver")
Cc: <Stable@vger.kernel.org>
Signed-off-by: Jonathan Cameron <Jonathan.Cameron@huawei.com>
Signed-off-by: Greg Kroah-Hartman <gregkh@linuxfoundation.org>

---
 drivers/iio/adc/xilinx-xadc-core.c |   10 ++++++++++
 1 file changed, 10 insertions(+)
diff mbox series

Patch

--- a/drivers/iio/adc/xilinx-xadc-core.c
+++ b/drivers/iio/adc/xilinx-xadc-core.c
@@ -785,6 +785,16 @@  static int xadc_preenable(struct iio_dev
 	if (ret)
 		goto err;
 
+	/*
+	 * In simultaneous mode the upper and lower aux channels are samples at
+	 * the same time. In this mode the upper 8 bits in the sequencer
+	 * register are don't care and the lower 8 bits control two channels
+	 * each. As such we must set the bit if either the channel in the lower
+	 * group or the upper group is enabled.
+	 */
+	if (seq_mode == XADC_CONF1_SEQ_SIMULTANEOUS)
+		scan_mask = ((scan_mask >> 8) | scan_mask) & 0xff0000;
+
 	ret = xadc_write_adc_reg(xadc, XADC_REG_SEQ(1), scan_mask >> 16);
 	if (ret)
 		goto err;