diff mbox series

[4.19,057/116] scsi: sd: Fix optimal I/O size for devices that change reported values

Message ID 20200401161549.957448642@linuxfoundation.org
State Superseded
Headers show
Series None | expand

Commit Message

Greg KH April 1, 2020, 4:17 p.m. UTC
From: Martin K. Petersen <martin.petersen@oracle.com>

commit ea697a8bf5a4161e59806fab14f6e4a46dc7dcb0 upstream.

Some USB bridge devices will return a default set of characteristics during
initialization. And then, once an attached drive has spun up, substitute
the actual parameters reported by the drive. According to the SCSI spec,
the device should return a UNIT ATTENTION in case any reported parameters
change. But in this case the change is made silently after a small window
where default values are reported.

Commit a83da8a4509d ("scsi: sd: Optimal I/O size should be a multiple of
physical block size") validated the reported optimal I/O size against the
physical block size to overcome problems with devices reporting nonsensical
transfer sizes. However, this validation did not account for the fact that
aforementioned devices will return default values during a brief window
during spin-up. The subsequent change in reported characteristics would
invalidate the checking that had previously been performed.

Unset a previously configured optimal I/O size should the sanity checking
fail on subsequent revalidate attempts.

Link: https://lore.kernel.org/r/33fb522e-4f61-1b76-914f-c9e6a3553c9b@gmail.com
Cc: Bryan Gurney <bgurney@redhat.com>
Cc: <stable@vger.kernel.org>
Reported-by: Bernhard Sulzer <micraft.b@gmail.com>
Tested-by: Bernhard Sulzer <micraft.b@gmail.com>
Signed-off-by: Martin K. Petersen <martin.petersen@oracle.com>
Signed-off-by: Greg Kroah-Hartman <gregkh@linuxfoundation.org>

---
 drivers/scsi/sd.c |    4 +++-
 1 file changed, 3 insertions(+), 1 deletion(-)
diff mbox series

Patch

--- a/drivers/scsi/sd.c
+++ b/drivers/scsi/sd.c
@@ -3210,9 +3210,11 @@  static int sd_revalidate_disk(struct gen
 	if (sd_validate_opt_xfer_size(sdkp, dev_max)) {
 		q->limits.io_opt = logical_to_bytes(sdp, sdkp->opt_xfer_blocks);
 		rw_max = logical_to_sectors(sdp, sdkp->opt_xfer_blocks);
-	} else
+	} else {
+		q->limits.io_opt = 0;
 		rw_max = min_not_zero(logical_to_sectors(sdp, dev_max),
 				      (sector_t)BLK_DEF_MAX_SECTORS);
+	}
 
 	/* Do not exceed controller limit */
 	rw_max = min(rw_max, queue_max_hw_sectors(q));