@@ -65,7 +65,7 @@ ipq8064_mdio_read(struct mii_bus *bus, int phy_addr, int reg_offset)
((reg_offset << MII_REG_SHIFT) & MII_REG_MASK);
writel(miiaddr, priv->base + MII_ADDR_REG_ADDR);
- usleep_range(8, 10);
+ usleep_range(10, 13);
err = ipq8064_mdio_wait_busy(priv);
if (err)
@@ -90,7 +90,14 @@ ipq8064_mdio_write(struct mii_bus *bus, int phy_addr, int reg_offset, u16 data)
((reg_offset << MII_REG_SHIFT) & MII_REG_MASK);
writel(miiaddr, priv->base + MII_ADDR_REG_ADDR);
- usleep_range(8, 10);
+
+ /* For the specific reg 31 extra time is needed or the next
+ * read will produce garbage data.
+ */
+ if (reg_offset == 31)
+ usleep_range(30, 43);
+ else
+ usleep_range(10, 13);
return ipq8064_mdio_wait_busy(priv);
}
With the use of the qca8k dsa driver, some problem arised related to port status detection. With a load on a specific port (for example a simple speed test), the driver starts to behave in a strange way and garbage data is produced. To address this, enlarge the sleep delay and address a bug for the reg offset 31 that require additional delay for this specific reg. Signed-off-by: Ansuel Smith <ansuelsmth@gmail.com> --- drivers/net/mdio/mdio-ipq8064.c | 11 +++++++++-- 1 file changed, 9 insertions(+), 2 deletions(-)