diff mbox series

[02/41] mmc: host: omap_hsmmc: Separate setting voltage capabilities from bus power

Message ID 20170519081541.26753-3-kishon@ti.com
State Superseded
Headers show
Series None | expand

Commit Message

Kishon Vijay Abraham I May 19, 2017, 8:15 a.m. UTC 
Add a separate function to set the voltage capabilities of the host
controller. Voltage capabilities should be set only once during
controller initialization but bus power can be changed every time there
is a voltage switch and whenever a different card is inserted.
This allows omap_hsmmc_conf_bus_power to be invoked every time there
is a voltage switch.

Signed-off-by: Kishon Vijay Abraham I <kishon@ti.com>

Signed-off-by: Sekhar Nori <nsekhar@ti.com>

---
 drivers/mmc/host/omap_hsmmc.c | 28 +++++++++++++++++++---------
 1 file changed, 19 insertions(+), 9 deletions(-)

-- 
2.11.0
diff mbox series

Patch

diff --git a/drivers/mmc/host/omap_hsmmc.c b/drivers/mmc/host/omap_hsmmc.c
index 2000aaa359c8..42954efe12f7 100644
--- a/drivers/mmc/host/omap_hsmmc.c
+++ b/drivers/mmc/host/omap_hsmmc.c
@@ -1809,25 +1809,34 @@  static int omap_hsmmc_configure_wake_irq(struct omap_hsmmc_host *host)
 	return ret;
 }
 
+static void omap_hsmmc_set_capabilities(struct omap_hsmmc_host *host)
+{
+	u32 val;
+
+	val = OMAP_HSMMC_READ(host->base, CAPA);
+
+	/* Only MMC1 supports 3.0V */
+	if (host->pdata->controller_flags & OMAP_HSMMC_SUPPORTS_DUAL_VOLT)
+		val |= (VS30 | VS18);
+	else
+		val |= VS18;
+
+	OMAP_HSMMC_WRITE(host->base, CAPA, val);
+}
+
 static void omap_hsmmc_conf_bus_power(struct omap_hsmmc_host *host)
 {
-	u32 hctl, capa, value;
+	u32 hctl, value;
 
 	/* Only MMC1 supports 3.0V */
-	if (host->pdata->controller_flags & OMAP_HSMMC_SUPPORTS_DUAL_VOLT) {
+	if (host->pdata->controller_flags & OMAP_HSMMC_SUPPORTS_DUAL_VOLT)
 		hctl = SDVS30;
-		capa = VS30 | VS18;
-	} else {
+	else
 		hctl = SDVS18;
-		capa = VS18;
-	}
 
 	value = OMAP_HSMMC_READ(host->base, HCTL) & ~SDVS_MASK;
 	OMAP_HSMMC_WRITE(host->base, HCTL, value | hctl);
 
-	value = OMAP_HSMMC_READ(host->base, CAPA);
-	OMAP_HSMMC_WRITE(host->base, CAPA, value | capa);
-
 	/* Set SD bus power bit */
 	set_sd_bus_power(host);
 }
@@ -2134,6 +2143,7 @@  static int omap_hsmmc_probe(struct platform_device *pdev)
 
 	mmc->pm_caps |= mmc_pdata(host)->pm_caps;
 
+	omap_hsmmc_set_capabilities(host);
 	omap_hsmmc_conf_bus_power(host);
 
 	host->rx_chan = dma_request_chan(&pdev->dev, "rx");