@@ -97,6 +97,9 @@ void dw_pcie_prog_outbound_atu(struct dw_pcie *pci, int index, int type,
{
u32 retries, val;
+ if (pp->ops->cpu_addr_fixup)
+ cpu_addr = pp->ops->cpu_addr_fixup(cpu_addr);
+
if (pci->iatu_unroll_enabled) {
dw_pcie_writel_unroll(pci, index, PCIE_ATU_UNR_LOWER_BASE,
lower_32_bits(cpu_addr));
@@ -143,6 +143,7 @@ struct pcie_port {
};
struct dw_pcie_ops {
+ u64 (*cpu_addr_fixup)(u64 cpu_addr);
u32 (*readl_dbi)(struct dw_pcie *pcie, u32 reg);
void (*writel_dbi)(struct dw_pcie *pcie, u32 reg, u32 val);
int (*link_up)(struct dw_pcie *pcie);
Some platforms (like dra7xx) require only the least 28 bits of the corresponding 32 bit CPU address to be programmed in the address translation unit. This modified address is stored in io_base/mem_base/ cfg0_base/cfg1_base in dra7xx_pcie_host_init. While this is okay for host mode where the address range is fixed, device mode requires different addresses to be programmed based on the host buffer address. Add a new ops to get the least 28 bits of the corresponding 32 bit CPU address and invoke it before programming the address translation unit. Signed-off-by: Kishon Vijay Abraham I <kishon@ti.com> --- drivers/pci/dwc/pcie-designware.c | 3 +++ drivers/pci/dwc/pcie-designware.h | 1 + 2 files changed, 4 insertions(+) -- 1.7.9.5