mbox series

[v5,00/23] mtd: nand: denali: Denali NAND IP patch bomb

Message ID 1496836352-8016-1-git-send-email-yamada.masahiro@socionext.com
Headers show
Series mtd: nand: denali: Denali NAND IP patch bomb | expand

Message

Masahiro Yamada June 7, 2017, 11:52 a.m. UTC
This patch series intends to solve various problems.

[1] The driver just retrieves the OOB area as-is
    whereas the controller uses syndrome page layout.
[2] Many NAND chip specific parameters are hard-coded in the driver.
[3] ONFi devices are not working
[4] It can not read Bad Block Marker

Outstanding changes are:
- Fix raw/oob callbacks for syndrome page layout
- Implement setup_data_interface() callback
- Fix/implement more commands for ONFi devices
- Allow to skip the driver internal bounce buffer
- Support PIO in case DMA is not supported
- Switch from ->cmdfunc over to ->cmd_ctrl

18 patches were merged at v2.
11 patches were merged at v3.
2 patches were merged at 4.
Here is the rest of the series.

v1: https://lkml.org/lkml/2016/11/26/144
v2: https://lkml.org/lkml/2017/3/22/804
v3: https://lkml.org/lkml/2017/3/30/90


Masahiro Yamada (23):
  mtd: nand: add generic helpers to check, match, maximize ECC settings
  mtd: nand: add a shorthand to generate nand_ecc_caps structure
  mtd: nand: denali: avoid hard-coding ECC step, strength, bytes
  mtd: nand: denali: remove Toshiba and Hynix specific fixup code
  mtd: nand: denali_dt: add compatible strings for UniPhier SoC variants
  mtd: nand: denali: set NAND_ECC_CUSTOM_PAGE_ACCESS
  mtd: nand: denali: do not propagate NAND_STATUS_FAIL to waitfunc()
  mtd: nand: denali: remove unneeded find_valid_banks()
  mtd: nand: denali: handle timing parameters by setup_data_interface()
  mtd: nand: denali: rework interrupt handling
  mtd: nand: denali: fix NAND_CMD_STATUS handling
  mtd: nand: denali: fix NAND_CMD_PARAM handling
  mtd: nand: denali: switch over to cmd_ctrl instead of cmdfunc
  mtd: nand: denali: fix bank reset function to detect the number of
    chips
  mtd: nand: denali: use interrupt instead of polling for bank reset
  mtd: nand: denali: propagate page to helpers via function argument
  mtd: nand: denali: merge struct nand_buf into struct denali_nand_info
  mtd: nand: denali: use flag instead of register macro for direction
  mtd: nand: denali: fix raw and oob accessors for syndrome page layout
  mtd: nand: denali: support hardware-assisted erased page detection
  mtd: nand: denali: skip driver internal bounce buffer when possible
  mtd: nand: denali: use non-managed kmalloc() for DMA buffer
  mtd: nand: denali: enable bad block table scan

 .../devicetree/bindings/mtd/denali-nand.txt        |   13 +
 drivers/mtd/nand/denali.c                          | 1686 +++++++++-----------
 drivers/mtd/nand/denali.h                          |   60 +-
 drivers/mtd/nand/denali_dt.c                       |   33 +-
 drivers/mtd/nand/denali_pci.c                      |   10 +-
 drivers/mtd/nand/nand_base.c                       |  220 +++
 include/linux/mtd/nand.h                           |   47 +
 7 files changed, 1103 insertions(+), 966 deletions(-)

-- 
2.7.4

Comments

Masahiro Yamada June 8, 2017, 7:12 a.m. UTC | #1
2017-06-08 15:16 GMT+09:00 Masahiro Yamada <yamada.masahiro@socionext.com>:
> Hi Boris,

>

> 2017-06-07 20:52 GMT+09:00 Masahiro Yamada <yamada.masahiro@socionext.com>:

>> This patch series intends to solve various problems.

>>

>> [1] The driver just retrieves the OOB area as-is

>>     whereas the controller uses syndrome page layout.

>> [2] Many NAND chip specific parameters are hard-coded in the driver.

>> [3] ONFi devices are not working

>> [4] It can not read Bad Block Marker

>>

>> Outstanding changes are:

>> - Fix raw/oob callbacks for syndrome page layout

>> - Implement setup_data_interface() callback

>> - Fix/implement more commands for ONFi devices

>> - Allow to skip the driver internal bounce buffer

>> - Support PIO in case DMA is not supported

>> - Switch from ->cmdfunc over to ->cmd_ctrl

>

>

> I am planning v6, but

> how many can you pick-up from this series?

>

> I did not see your comments for 01-05, so are they applicable?

>

> Could you add

> Acked-by: Rob Herring <robh@kernel.org>

> for 05  (http://patchwork.ozlabs.org/patch/772388/)

>

> He had already acked it, but I just missed it.

>


BTW, this series can not apply to Boris's tree
because of the following commit.

commit 4a78cc644eed3cf2dae00c3a959910a86c140fd6
Author: Boris Brezillon <boris.brezillon@free-electrons.com>
Date:   Fri May 26 17:10:15 2017 +0200

    mtd: nand: Make sure drivers not supporting SET/GET_FEATURES
return -ENOTSUPP



I will send v6 rebased on nand/next branch.



-- 
Best Regards
Masahiro Yamada