@@ -950,7 +950,10 @@ static const struct ath12k_hw_params ath12k_hw_params[] = {
.vdev_start_delay = true,
.interface_modes = BIT(NL80211_IFTYPE_STATION) |
- BIT(NL80211_IFTYPE_AP),
+ BIT(NL80211_IFTYPE_AP) |
+ BIT(NL80211_IFTYPE_P2P_DEVICE) |
+ BIT(NL80211_IFTYPE_P2P_CLIENT) |
+ BIT(NL80211_IFTYPE_P2P_GO),
.supports_monitor = false,
.idle_ps = true,
@@ -5635,17 +5635,25 @@ static int ath12k_mac_op_add_interface(struct ieee80211_hw *hw,
case NL80211_IFTYPE_UNSPECIFIED:
case NL80211_IFTYPE_STATION:
arvif->vdev_type = WMI_VDEV_TYPE_STA;
+ if (vif->p2p)
+ arvif->vdev_subtype = WMI_VDEV_SUBTYPE_P2P_CLIENT;
break;
case NL80211_IFTYPE_MESH_POINT:
arvif->vdev_subtype = WMI_VDEV_SUBTYPE_MESH_11S;
fallthrough;
case NL80211_IFTYPE_AP:
arvif->vdev_type = WMI_VDEV_TYPE_AP;
+ if (vif->p2p)
+ arvif->vdev_subtype = WMI_VDEV_SUBTYPE_P2P_GO;
break;
case NL80211_IFTYPE_MONITOR:
arvif->vdev_type = WMI_VDEV_TYPE_MONITOR;
ar->monitor_vdev_id = bit;
break;
+ case NL80211_IFTYPE_P2P_DEVICE:
+ arvif->vdev_type = WMI_VDEV_TYPE_STA;
+ arvif->vdev_subtype = WMI_VDEV_SUBTYPE_P2P_DEVICE;
+ break;
default:
WARN_ON(1);
break;
Now that all the necessary pieces are implemented we can enable P2P support for WCN7850. Tested-on: WCN7850 hw2.0 PCI WLAN.HMT.1.0.c5-00481-QCAHMTSWPL_V1.0_V2.0_SILICONZ-3 Signed-off-by: Kang Yang <quic_kangyang@quicinc.com> --- drivers/net/wireless/ath/ath12k/hw.c | 5 ++++- drivers/net/wireless/ath/ath12k/mac.c | 8 ++++++++ 2 files changed, 12 insertions(+), 1 deletion(-)