@@ -1315,6 +1315,18 @@ static void brcmf_pcie_down(struct device *dev)
{
}
+static int brcmf_pcie_preinit(struct device *dev)
+{
+ struct brcmf_bus *bus_if = dev_get_drvdata(dev);
+ struct brcmf_pciedev *buspub = bus_if->bus_priv.pcie;
+
+ brcmf_dbg(PCIE, "Enter\n");
+
+ brcmf_pcie_intr_enable(buspub->devinfo);
+ brcmf_pcie_hostready(buspub->devinfo);
+
+ return 0;
+}
static int brcmf_pcie_tx(struct device *dev, struct sk_buff *skb)
{
@@ -1423,6 +1435,7 @@ static int brcmf_pcie_reset(struct device *dev)
}
static const struct brcmf_bus_ops brcmf_pcie_bus_ops = {
+ .preinit = brcmf_pcie_preinit,
.txdata = brcmf_pcie_tx,
.stop = brcmf_pcie_down,
.txctl = brcmf_pcie_tx_ctlpkt,
@@ -1795,9 +1808,6 @@ static void brcmf_pcie_setup(struct device *dev, int ret,
init_waitqueue_head(&devinfo->mbdata_resp_wait);
- brcmf_pcie_intr_enable(devinfo);
- brcmf_pcie_hostready(devinfo);
-
ret = brcmf_attach(&devinfo->pdev->dev);
if (ret)
goto fail;
The driver was enabling IRQs before the message processing was initialized. This could cause IRQs to come in too early and crash the driver. Instead, move the IRQ enable and hostready to a bus preinit function, at which point everything is properly initialized. Fixes: 9e37f045d5e7 ("brcmfmac: Adding PCIe bus layer support.") Reviewed-by: Linus Walleij <linus.walleij@linaro.org> Reviewed-by: Arend van Spriel <arend.vanspriel@broadcom.com> Signed-off-by: Hector Martin <marcan@marcan.st> --- .../wireless/broadcom/brcm80211/brcmfmac/pcie.c | 16 +++++++++++++--- 1 file changed, 13 insertions(+), 3 deletions(-)