| Message ID | 20210319161520.3590510-1-bryan.odonoghue@linaro.org |
|---|---|
| Headers | show |
| Series | wcn36xx: Enable downstream consistent Wake on Lan | expand |
On 3/19/21 9:15 AM, Bryan O'Donoghue wrote: > V3: > - Ifdefs an IPV6 specific function which will not compile unless CONFIG_IPV6 > is swithced on - Kernel test robot > > V2: > - Drops work-around for scan in progress > This is not required on a tip of tree kernel - Kalle > - Churn out "this patch" form commit logs - Kalle > - Adds comment about packing structures to commit log patch #8 - Kalle > - Moves enablement of magic-packet and GTK rekey to last patch > This means that the functionality is only switched on when the full > series has been applied - Kalle > > https://www.spinics.net/lists/linux-wireless/msg206927.html > > V1: > This series enables Wake on WLAN for the wcn36xx. Downstream implements two > competing methods for WoWLAN, only one of which is used in practice. > > 1. The downstream prima driver and firmware have a dedicated wowlan SMD > command set, however for whatever reason, the downstream driver doesn't > actually use that code path for suspend/resume. > Similarly the downstream kernel will mask out the SMD interrupt when > entering into suspend, so its clear the firmware assisted wowlan command > is not used at all. > In short, the code is implemented but not used. > > 2. The alternative version of wake on wlan implemented downstream does > A. An RXP filter > B. Frimware ipv4 ARP offload > C. Frimware ipv6 namesapece offload > D. GTK replay counter save/update on suspend/resume > > This patchset replicates method #2 since it is the only method that > actually works. When replicating the functionality from downstream to > upsteam I found the RXP filter step to be redundant, so I skipped that. > > Verified on Android/4.19 with qcom out-of-tree low-power patch on wcn3680. > Verified on Debian/kvalo/master on wcn3680 and wcn3620. > > The Debian/upstream test doesn't include the low-power patches from qcom so > the time it takes the system to wake up when pinged is longer. > > Test method: > > 1. Enable magic packet wakeup on target > iw phy0 wowlan enable magic-packet > iw phy0 wowlan show > > 2. Flush arp tables on host > sudo ip -s -s neigh flush all > sudo ip -6 -s -s neigh flush all > > 3. Suspend device > echo 1 > /sys/kernel/debug/clk/debug_suspend > echo mem > /sys/power/state ; cat /sys/kernel/debug/rpm_stats > echo 0 > /sys/module/wcn36xx/parameters/debug_mask > dmesg > > 4. Ping either ipv4 or ipv6 > ping 192.168.0.85 > ping -6 fe80::6455:44ff:fe33:2211%wlo1 Tested-by: Benjamin Li <benl@squareup.com> Independently re-tested on Square Terminal with WCN3680B using these steps on a recently rebased tree (last month). Used the Linaro DB410c Debian image as userspace & called nmcli to enable WoWLAN instead of iw directly. sudo nmcli dev wifi connect <SSID> password "<password>" sudo nmcli connection modify <SSID> connection.autoconnect yes # (^ need to set MAC address in device tree for autoconnect at boot) sudo nmcli connection modify <SSID> wifi.wake-on-wlan magic sudo service network-manager restart - arping returns the WLAN MAC address without waking up the device from suspend. - ping wakes up the device from suspend (it does take ~8-16s without LPM patches). - Device stayed connected after leaving device in suspend for longer than my network's GTK rekeying interval (1hr) and then waking from suspend. > > In both cases using Wireshark we see the target system receive an ARP or > NS6 lookup and respond, followed by the host sending a ping or ping6 and > the target system coming out of suspend. > > Similarly watching GTK keying on the AP when the device is in suspend, we > see the firmware successfully rekey and when we resume, the host picking up > the rekey material with persistence of the WiFi link during suspend/resume. > > commit: 5336fad96e8f ("wcn36xx: Enable firmware offloaded keepalive") > ensures that the link is kept alive in suspend, this additional set gives > the ability to > > - Resolve ARP/NS6 lookups without waking the system > - Rekeying in suspend > - Suspending and resuming based on received datagram > > https://git.linaro.org/people/bryan.odonoghue/kernel.git/log/?h=ath.master-wcn36xx-fw-offload-suspend-resume > > Bryan O'Donoghue (12): > wcn36xx: Return result of set_power_params in suspend > wcn36xx: Run suspend for the first ieee80211_vif > wcn36xx: Add ipv4 ARP offload support in suspend > wcn36xx: Do not flush indication queue on suspend/resume > wcn36xx: Add ipv6 address tracking > wcn36xx: Add ipv6 namespace offload in suspend > wcn36xx: Add set_rekey_data callback > wcn36xx: Add GTK offload to WoWLAN path > wcn36xx: Add GTK offload info to WoWLAN resume > wcn36xx: Add Host suspend indication support > wcn36xx: Add host resume request support > wcn36xx: Enable WOWLAN flags > > drivers/net/wireless/ath/wcn36xx/hal.h | 20 +- > drivers/net/wireless/ath/wcn36xx/main.c | 118 ++++++++- > drivers/net/wireless/ath/wcn36xx/smd.c | 265 +++++++++++++++++++++ > drivers/net/wireless/ath/wcn36xx/smd.h | 17 ++ > drivers/net/wireless/ath/wcn36xx/wcn36xx.h | 14 ++ > 5 files changed, 420 insertions(+), 14 deletions(-) >
On 25/03/2021 19:52, Benjamin Li wrote: > Independently re-tested on Square Terminal with WCN3680B using these steps > on a recently rebased tree (last month). appreciated _______________________________________________ wcn36xx mailing list wcn36xx@lists.infradead.org http://lists.infradead.org/mailman/listinfo/wcn36xx
V3: - Ifdefs an IPV6 specific function which will not compile unless CONFIG_IPV6 is swithced on - Kernel test robot V2: - Drops work-around for scan in progress This is not required on a tip of tree kernel - Kalle - Churn out "this patch" form commit logs - Kalle - Adds comment about packing structures to commit log patch #8 - Kalle - Moves enablement of magic-packet and GTK rekey to last patch This means that the functionality is only switched on when the full series has been applied - Kalle https://www.spinics.net/lists/linux-wireless/msg206927.html V1: This series enables Wake on WLAN for the wcn36xx. Downstream implements two competing methods for WoWLAN, only one of which is used in practice. 1. The downstream prima driver and firmware have a dedicated wowlan SMD command set, however for whatever reason, the downstream driver doesn't actually use that code path for suspend/resume. Similarly the downstream kernel will mask out the SMD interrupt when entering into suspend, so its clear the firmware assisted wowlan command is not used at all. In short, the code is implemented but not used. 2. The alternative version of wake on wlan implemented downstream does A. An RXP filter B. Frimware ipv4 ARP offload C. Frimware ipv6 namesapece offload D. GTK replay counter save/update on suspend/resume This patchset replicates method #2 since it is the only method that actually works. When replicating the functionality from downstream to upsteam I found the RXP filter step to be redundant, so I skipped that. Verified on Android/4.19 with qcom out-of-tree low-power patch on wcn3680. Verified on Debian/kvalo/master on wcn3680 and wcn3620. The Debian/upstream test doesn't include the low-power patches from qcom so the time it takes the system to wake up when pinged is longer. Test method: 1. Enable magic packet wakeup on target iw phy0 wowlan enable magic-packet iw phy0 wowlan show 2. Flush arp tables on host sudo ip -s -s neigh flush all sudo ip -6 -s -s neigh flush all 3. Suspend device echo 1 > /sys/kernel/debug/clk/debug_suspend echo mem > /sys/power/state ; cat /sys/kernel/debug/rpm_stats echo 0 > /sys/module/wcn36xx/parameters/debug_mask dmesg 4. Ping either ipv4 or ipv6 ping 192.168.0.85 ping -6 fe80::6455:44ff:fe33:2211%wlo1 In both cases using Wireshark we see the target system receive an ARP or NS6 lookup and respond, followed by the host sending a ping or ping6 and the target system coming out of suspend. Similarly watching GTK keying on the AP when the device is in suspend, we see the firmware successfully rekey and when we resume, the host picking up the rekey material with persistence of the WiFi link during suspend/resume. commit: 5336fad96e8f ("wcn36xx: Enable firmware offloaded keepalive") ensures that the link is kept alive in suspend, this additional set gives the ability to - Resolve ARP/NS6 lookups without waking the system - Rekeying in suspend - Suspending and resuming based on received datagram https://git.linaro.org/people/bryan.odonoghue/kernel.git/log/?h=ath.master-wcn36xx-fw-offload-suspend-resume Bryan O'Donoghue (12): wcn36xx: Return result of set_power_params in suspend wcn36xx: Run suspend for the first ieee80211_vif wcn36xx: Add ipv4 ARP offload support in suspend wcn36xx: Do not flush indication queue on suspend/resume wcn36xx: Add ipv6 address tracking wcn36xx: Add ipv6 namespace offload in suspend wcn36xx: Add set_rekey_data callback wcn36xx: Add GTK offload to WoWLAN path wcn36xx: Add GTK offload info to WoWLAN resume wcn36xx: Add Host suspend indication support wcn36xx: Add host resume request support wcn36xx: Enable WOWLAN flags drivers/net/wireless/ath/wcn36xx/hal.h | 20 +- drivers/net/wireless/ath/wcn36xx/main.c | 118 ++++++++- drivers/net/wireless/ath/wcn36xx/smd.c | 265 +++++++++++++++++++++ drivers/net/wireless/ath/wcn36xx/smd.h | 17 ++ drivers/net/wireless/ath/wcn36xx/wcn36xx.h | 14 ++ 5 files changed, 420 insertions(+), 14 deletions(-) -- 2.30.1 _______________________________________________ wcn36xx mailing list wcn36xx@lists.infradead.org http://lists.infradead.org/mailman/listinfo/wcn36xx