mbox series

[0/6] Rongpin RP-H6B support (and support for GL850G)

Message ID 20221127073140.2093897-1-uwu@icenowy.me
Headers show
Series Rongpin RP-H6B support (and support for GL850G) | expand

Message

Icenowy Zheng Nov. 27, 2022, 7:31 a.m. UTC 
This patchset adds support for Rongpin RP-H6B, and as a dependency,
power sequence support for its onboard USB hub, GL850G.

The first 3 patches are for GL850G, adding a binding for it and adding
its support to onboard_usb_hub driver.

The last 3 patches are for RP-H6B, also 2 for adding a binding and 1 for
the real DT.

Icenowy Zheng (6):
  dt-bindings: vendor-prefixes: add Genesys Logic
  dt-bindings: usb: Add binding for Genesys Logic GL850G hub controller
  usb: misc: onboard_usb_hub: add Genesys Logic GL850G hub support
  vendor-prefixes: Add Shenzhen Rongpin Electronics Co., Ltd
  dt-bindings: arm: sunxi: add Rongpin RP-H6B board
  arm64: dts: allwinner: h6: add Rongpin RP-H6C SoM and RP-H6B board

 .../devicetree/bindings/arm/sunxi.yaml        |   6 +
 .../bindings/usb/genesys,gl850g.yaml          |  48 ++++
 .../devicetree/bindings/vendor-prefixes.yaml  |   4 +
 arch/arm64/boot/dts/allwinner/Makefile        |   1 +
 .../boot/dts/allwinner/sun50i-h6-rp-h6b.dts   | 239 ++++++++++++++++++
 .../boot/dts/allwinner/sun50i-h6-rp-h6c.dtsi  | 180 +++++++++++++
 drivers/usb/misc/onboard_usb_hub.c            |   2 +
 drivers/usb/misc/onboard_usb_hub.h            |   5 +
 8 files changed, 485 insertions(+)
 create mode 100644 Documentation/devicetree/bindings/usb/genesys,gl850g.yaml
 create mode 100644 arch/arm64/boot/dts/allwinner/sun50i-h6-rp-h6b.dts
 create mode 100644 arch/arm64/boot/dts/allwinner/sun50i-h6-rp-h6c.dtsi

Comments

Krzysztof Kozlowski Nov. 28, 2022, 8:48 a.m. UTC | #1 
On 27/11/2022 08:31, Icenowy Zheng wrote:
> Rongpin RP-H6B is a development board with RP-H6C SoM, which uses an
> Allwinner H6 SoC.
> 
> Add compatible strings for it, including the board-specific compatible
> and the SoM compatible.
> 


Acked-by: Krzysztof Kozlowski <krzysztof.kozlowski@linaro.org>

Best regards,
Krzysztof