diff mbox series

[v2,3/7] spi: rspi: Increase bit rate accuracy on RZ/A

Message ID 20200819125904.20938-4-geert+renesas@glider.be
State Accepted
Commit feace90233a8cd44a18902216657279c3932d471
Headers show
Series spi: rspi: Bit rate improvements | expand

Commit Message

Geert Uytterhoeven Aug. 19, 2020, 12:59 p.m. UTC 
rspi_rz_set_config_register() favors high values of "brdv" over high
values of "spbr".  As "brdv" is not a plain divider, but controls a
power-of-two divider, this may cause the selection of non-optimal
divider values.  E.g. on RSK+RZA1, when 3.8 MHz is requested, the actual
configured bit rate is 2.08 MHz (spbr = 1, brdv = 3), while 3.7 MHz
would be possible (spbr = 8, brdv = 0).

Fix this by only resorting to higher "brdv" values when really needed.
This makes the driver always pick optimal divider values on RZ/A.

Signed-off-by: Geert Uytterhoeven <geert+renesas@glider.be>
---
v2:
  - No changes.

 drivers/spi/spi-rspi.c | 8 +++-----
 1 file changed, 3 insertions(+), 5 deletions(-)
diff mbox series

Patch

diff --git a/drivers/spi/spi-rspi.c b/drivers/spi/spi-rspi.c
index 450a42ec2141a895..ad4ac867170b101a 100644
--- a/drivers/spi/spi-rspi.c
+++ b/drivers/spi/spi-rspi.c
@@ -298,15 +298,13 @@  static int rspi_rz_set_config_register(struct rspi_data *rspi, int access_size)
 	rspi_write8(rspi, rspi->sppcr, RSPI_SPPCR);
 
 	clksrc = clk_get_rate(rspi->clk);
-	while (brdv < 3) {
-		if (rspi->speed_hz >= clksrc/4) /* 4=(CLK/2)/2 */
-			break;
+	spbr = DIV_ROUND_UP(clksrc, 2 * rspi->speed_hz) - 1;
+	while (spbr > 255 && brdv < 3) {
 		brdv++;
-		clksrc /= 2;
+		spbr = DIV_ROUND_UP(spbr + 1, 2) - 1;
 	}
 
 	/* Sets transfer bit rate */
-	spbr = DIV_ROUND_UP(clksrc, 2 * rspi->speed_hz) - 1;
 	rspi_write8(rspi, clamp(spbr, 0, 255), RSPI_SPBR);
 	rspi->spcmd |= SPCMD_BRDV(brdv);