@@ -334,7 +334,6 @@ struct sc16is7xx_one {
struct sc16is7xx_port {
const struct sc16is7xx_devtype *devtype;
- struct regmap *regmap;
struct clk *clk;
#ifdef CONFIG_GPIOLIB
struct gpio_chip gpio;
@@ -1434,7 +1433,8 @@ static void sc16is7xx_setup_irda_ports(struct sc16is7xx_port *s)
/*
* Configure ports designated to operate as modem control lines.
*/
-static int sc16is7xx_setup_mctrl_ports(struct sc16is7xx_port *s)
+static int sc16is7xx_setup_mctrl_ports(struct sc16is7xx_port *s,
+ struct regmap *regmap)
{
int i;
int ret;
@@ -1463,7 +1463,7 @@ static int sc16is7xx_setup_mctrl_ports(struct sc16is7xx_port *s)
if (s->mctrl_mask)
regmap_update_bits(
- s->regmap,
+ regmap,
SC16IS7XX_IOCONTROL_REG,
SC16IS7XX_IOCONTROL_MODEM_A_BIT |
SC16IS7XX_IOCONTROL_MODEM_B_BIT, s->mctrl_mask);
@@ -1495,6 +1495,10 @@ static int sc16is7xx_probe(struct device *dev,
* This device does not have an identification register that would
* tell us if we are really connected to the correct device.
* The best we can do is to check if communication is at all possible.
+ *
+ * Note: regmap[0] is used in the probe function to access registers
+ * common to all channels/ports, as it is guaranteed to be present on
+ * all variants.
*/
ret = regmap_read(regmaps[0], SC16IS7XX_LSR_REG, &val);
if (ret < 0)
@@ -1530,7 +1534,6 @@ static int sc16is7xx_probe(struct device *dev,
return -EINVAL;
}
- s->regmap = regmaps[0];
s->devtype = devtype;
dev_set_drvdata(dev, s);
mutex_init(&s->efr_lock);
@@ -1545,7 +1548,7 @@ static int sc16is7xx_probe(struct device *dev,
sched_set_fifo(s->kworker_task);
/* reset device, purging any pending irq / data */
- regmap_write(s->regmap, SC16IS7XX_IOCONTROL_REG,
+ regmap_write(regmaps[0], SC16IS7XX_IOCONTROL_REG,
SC16IS7XX_IOCONTROL_SRESET_BIT);
for (i = 0; i < devtype->nr_uart; ++i) {
@@ -1616,7 +1619,7 @@ static int sc16is7xx_probe(struct device *dev,
sc16is7xx_setup_irda_ports(s);
- ret = sc16is7xx_setup_mctrl_ports(s);
+ ret = sc16is7xx_setup_mctrl_ports(s, regmaps[0]);
if (ret)
goto out_ports;