@@ -510,10 +510,8 @@ static void stm32_usart_tx_dma_complete(void *arg)
{
struct uart_port *port = arg;
struct stm32_port *stm32port = to_stm32_port(port);
- const struct stm32_usart_offsets *ofs = &stm32port->info->ofs;
unsigned long flags;
- stm32_usart_clr_bits(port, ofs->cr3, USART_CR3_DMAT);
stm32_usart_tx_dma_terminate(stm32port);
/* Let's see if we have pending data to send */
@@ -602,7 +600,6 @@ static void stm32_usart_transmit_chars_pio(struct uart_port *port)
static void stm32_usart_transmit_chars_dma(struct uart_port *port)
{
struct stm32_port *stm32port = to_stm32_port(port);
- const struct stm32_usart_offsets *ofs = &stm32port->info->ofs;
struct circ_buf *xmit = &port->state->xmit;
struct dma_async_tx_descriptor *desc = NULL;
unsigned int count;
@@ -667,8 +664,6 @@ static void stm32_usart_transmit_chars_dma(struct uart_port *port)
/* Issue pending DMA TX requests */
dma_async_issue_pending(stm32port->tx_ch);
- stm32_usart_set_bits(port, ofs->cr3, USART_CR3_DMAT);
-
uart_xmit_advance(port, count);
return;
@@ -1270,6 +1265,9 @@ static void stm32_usart_set_termios(struct uart_port *port,
cr3 |= USART_CR3_DDRE;
}
+ if (stm32_port->tx_ch)
+ cr3 |= USART_CR3_DMAT;
+
if (rs485conf->flags & SER_RS485_ENABLED) {
stm32_usart_config_reg_rs485(&cr1, &cr3,
rs485conf->delay_rts_before_send,
DMAT is a configuration bit so it should be set at the startup of uart port and not when a DMA transfer begins. This patch move set of DMAT into set_termios and remove DMAT reset except in shutdown. Signed-off-by: Valentin Caron <valentin.caron@foss.st.com> --- drivers/tty/serial/stm32-usart.c | 8 +++----- 1 file changed, 3 insertions(+), 5 deletions(-)