@@ -1365,11 +1365,6 @@ static int lpuart_config_rs485(struct uart_port *port,
~(UARTMODEM_TXRTSPOL | UARTMODEM_TXRTSE);
writeb(modem, sport->port.membase + UARTMODEM);
- /* clear unsupported configurations */
- rs485->delay_rts_before_send = 0;
- rs485->delay_rts_after_send = 0;
- rs485->flags &= ~SER_RS485_RX_DURING_TX;
-
if (rs485->flags & SER_RS485_ENABLED) {
/* Enable auto RS-485 RTS mode */
modem |= UARTMODEM_TXRTSE;
@@ -1400,11 +1395,6 @@ static int lpuart32_config_rs485(struct uart_port *port,
& ~(UARTMODEM_TXRTSPOL | UARTMODEM_TXRTSE);
lpuart32_write(&sport->port, modem, UARTMODIR);
- /* clear unsupported configurations */
- rs485->delay_rts_before_send = 0;
- rs485->delay_rts_after_send = 0;
- rs485->flags &= ~SER_RS485_RX_DURING_TX;
-
if (rs485->flags & SER_RS485_ENABLED) {
/* Enable auto RS-485 RTS mode */
modem |= UARTMODEM_TXRTSE;
@@ -2723,13 +2713,6 @@ static int lpuart_probe(struct platform_device *pdev)
if (ret)
goto failed_get_rs485;
- if (sport->port.rs485.flags & SER_RS485_RX_DURING_TX)
- dev_err(&pdev->dev, "driver doesn't support RX during TX\n");
-
- if (sport->port.rs485.delay_rts_before_send ||
- sport->port.rs485.delay_rts_after_send)
- dev_err(&pdev->dev, "driver doesn't support RTS delays\n");
-
uart_rs485_config(&sport->port);
ret = devm_request_irq(&pdev->dev, sport->port.irq, handler, 0,
Serial core handles serial_rs485 sanitization. Remove custom sanitization from lpuart_config_rs485. This change loses dev_err when SER_RS485_RX_DURING_TX is set due to incorrect configuration. Other drivers do not do similar prinout for full-duplex case and it should be done in serial core if it is desirable to notify on this condition. Personally, I doesn't see it important because the kernel gracefully downgrades to half-duplex. Signed-off-by: Ilpo Järvinen <ilpo.jarvinen@linux.intel.com> --- drivers/tty/serial/fsl_lpuart.c | 17 ----------------- 1 file changed, 17 deletions(-)