@@ -59,6 +59,8 @@
#define S3C64XX_SPI_MODE_BUS_TSZ_HALFWORD (1<<17)
#define S3C64XX_SPI_MODE_BUS_TSZ_WORD (2<<17)
#define S3C64XX_SPI_MODE_BUS_TSZ_MASK (3<<17)
+#define S3C64XX_SPI_MODE_RX_RDY_LVL GENMASK(16, 11)
+#define S3C64XX_SPI_MODE_RX_RDY_LVL_SHIFT 11
#define S3C64XX_SPI_MODE_SELF_LOOPBACK (1<<3)
#define S3C64XX_SPI_MODE_RXDMA_ON (1<<2)
#define S3C64XX_SPI_MODE_TXDMA_ON (1<<1)
@@ -567,6 +569,7 @@ static int s3c64xx_wait_for_pio(struct s3c64xx_spi_driver_data *sdd,
{
void __iomem *regs = sdd->regs;
unsigned long val;
+ unsigned long time;
u32 status;
int loops;
u32 cpy_len;
@@ -577,6 +580,11 @@ static int s3c64xx_wait_for_pio(struct s3c64xx_spi_driver_data *sdd,
ms = xfer->len * 8 * 1000 / sdd->cur_speed;
ms += 10; /* some tolerance */
+ val = msecs_to_jiffies(ms);
+ time = wait_for_completion_timeout(&sdd->xfer_completion, val);
+ if (!time)
+ return -EIO;
+
val = msecs_to_loops(ms);
do {
status = readl(regs + S3C64XX_SPI_STATUS);
@@ -743,6 +751,8 @@ static int s3c64xx_spi_transfer_one(struct spi_master *master,
u32 speed;
u8 bpw;
unsigned long flags;
+ u32 rdy_lv;
+ u32 val;
reinit_completion(&sdd->xfer_completion);
@@ -763,17 +773,41 @@ static int s3c64xx_spi_transfer_one(struct spi_master *master,
sdd->rx_dma.ch && sdd->tx_dma.ch) {
use_dma = 1;
- } else if (xfer->len > fifo_len) {
+ } else if (xfer->len >= fifo_len) {
tx_buf = xfer->tx_buf;
rx_buf = xfer->rx_buf;
origin_len = xfer->len;
-
target_len = xfer->len;
- if (xfer->len > fifo_len)
- xfer->len = fifo_len;
+ xfer->len = fifo_len - 1;
}
do {
+ if (!use_dma) {
+ reinit_completion(&sdd->xfer_completion);
+
+ rdy_lv = xfer->len;
+ /* Setup RDY_FIFO trigger Level
+ * RDY_LVL =
+ * fifo_lvl upto 64 byte -> N bytes
+ * 128 byte -> RDY_LVL * 2 bytes
+ * 256 byte -> RDY_LVL * 4 bytes
+ */
+ if (fifo_len == 128)
+ rdy_lv /= 2;
+ else if (fifo_len == 256)
+ rdy_lv /= 4;
+
+ val = readl(sdd->regs + S3C64XX_SPI_MODE_CFG);
+ val &= ~S3C64XX_SPI_MODE_RX_RDY_LVL;
+ val |= (rdy_lv << S3C64XX_SPI_MODE_RX_RDY_LVL_SHIFT);
+ writel(val, sdd->regs + S3C64XX_SPI_MODE_CFG);
+
+ /* Enable FIFO_RDY_EN IRQ */
+ val = readl(sdd->regs + S3C64XX_SPI_INT_EN);
+ writel((val | S3C64XX_SPI_INT_RX_FIFORDY_EN),
+ sdd->regs + S3C64XX_SPI_INT_EN);
+
+ }
spin_lock_irqsave(&sdd->lock, flags);
/* Pending only which is to be done */
@@ -834,8 +868,8 @@ static int s3c64xx_spi_transfer_one(struct spi_master *master,
if (xfer->rx_buf)
xfer->rx_buf += xfer->len;
- if (target_len > fifo_len)
- xfer->len = fifo_len;
+ if (target_len >= fifo_len)
+ xfer->len = fifo_len - 1;
else
xfer->len = target_len;
}
@@ -1005,6 +1039,14 @@ static irqreturn_t s3c64xx_spi_irq(int irq, void *data)
dev_err(&spi->dev, "TX underrun\n");
}
+ if (val & S3C64XX_SPI_ST_RX_FIFORDY) {
+ complete(&sdd->xfer_completion);
+ /* No pending clear irq, turn-off INT_EN_RX_FIFO_RDY */
+ val = readl(sdd->regs + S3C64XX_SPI_INT_EN);
+ writel((val & ~S3C64XX_SPI_INT_RX_FIFORDY_EN),
+ sdd->regs + S3C64XX_SPI_INT_EN);
+ }
+
/* Clear the pending irq by setting and then clearing it */
writel(clr, sdd->regs + S3C64XX_SPI_PENDING_CLR);
writel(0, sdd->regs + S3C64XX_SPI_PENDING_CLR);
This patch adds IRQ based PIO mode instead of cpu polling. By using the FIFO trigger level, interrupts are received. CPU consumption is reduced in PIO mode because registers are not constantly checked. Signed-off-by: Jaewon Kim <jaewon02.kim@samsung.com> --- drivers/spi/spi-s3c64xx.c | 54 ++++++++++++++++++++++++++++++++++----- 1 file changed, 48 insertions(+), 6 deletions(-)