@@ -1095,10 +1095,18 @@ static int bq25890_vbus_is_enabled(struct regulator_dev *rdev)
return bq25890_field_read(bq, F_OTG_CFG);
}
+static int bq25890_vbus_get_voltage(struct regulator_dev *rdev)
+{
+ struct bq25890_device *bq = rdev_get_drvdata(rdev);
+
+ return bq25890_get_vbus_voltage(bq);
+}
+
static const struct regulator_ops bq25890_vbus_ops = {
.enable = bq25890_vbus_enable,
.disable = bq25890_vbus_disable,
.is_enabled = bq25890_vbus_is_enabled,
+ .get_voltage = bq25890_vbus_get_voltage,
};
static const struct regulator_desc bq25890_vbus_desc = {
@@ -1107,8 +1115,6 @@ static const struct regulator_desc bq25890_vbus_desc = {
.type = REGULATOR_VOLTAGE,
.owner = THIS_MODULE,
.ops = &bq25890_vbus_ops,
- .fixed_uV = 5000000,
- .n_voltages = 1,
};
static int bq25890_register_regulator(struct bq25890_device *bq)
@@ -1120,9 +1126,6 @@ static int bq25890_register_regulator(struct bq25890_device *bq)
};
struct regulator_dev *reg;
- if (!IS_ERR_OR_NULL(bq->usb_phy))
- return 0;
-
if (pdata)
cfg.init_data = pdata->regulator_init_data;
The chip is capable of reporting Vbus voltage, add .get_voltage implementation to Vbus regulator to report current Vbus voltage. This requires for the Vbus regulator to be registered always instead of the current state where the regulator is registered only in case USB PHY is not found. Do not provide Vbus regulator enable/disable ops in case USB PHY is present, as they would race with USB PHY notifier which is also used to toggle OTG boost mode. Signed-off-by: Marek Vasut <marex@denx.de> --- Cc: Andy Shevchenko <andriy.shevchenko@linux.intel.com> Cc: Hans de Goede <hdegoede@redhat.com> Cc: Michał Mirosław <mirq-linux@rere.qmqm.pl> Cc: Sebastian Reichel <sebastian.reichel@collabora.com> To: linux-pm@vger.kernel.org --- V2: Simplify the Vbus regulator registration, quoting Hans: " AFAIK if the Vboost regulator is not referenced in dt because it is controller through the usb-phy framework then valid_ops_mask will be empty, so the 2 sets of ops + 2 descs are not necessary I believe. So I believe this can be simplified to just adding bq25890_vbus_get_voltage to the ops, dropping .fixed_uV and .n_voltages from the desc, and just completely dropping the IS_ERR_OR_NULL(bq->usb_phy) check. " --- drivers/power/supply/bq25890_charger.c | 13 ++++++++----- 1 file changed, 8 insertions(+), 5 deletions(-)