mbox series

[v6,00/18] mtd: nand: denali: Denali NAND IP patch bomb

Message ID 1497330250-17348-1-git-send-email-yamada.masahiro@socionext.com
Headers show
Series mtd: nand: denali: Denali NAND IP patch bomb | expand

Message

Masahiro Yamada June 13, 2017, 5:03 a.m. UTC 
This patch series intends to solve various problems.

[1] The driver just retrieves the OOB area as-is
    whereas the controller uses syndrome page layout.
[2] ONFi devices are not working
[3] It can not read Bad Block Marker

Outstanding changes are:
 - Fix raw/oob callbacks for syndrome page layout
 - Implement setup_data_interface() callback
 - Fix/implement more commands for ONFi devices
 - Allow to skip the driver internal bounce buffer
 - Support PIO in case DMA is not supported
 - Switch from ->cmdfunc over to ->cmd_ctrl

18 patches were merged by v2.
11 patches were merged by v3.
2 patches were merged by v4.
5 patches were merged by v5.
Here is the rest of the series.

v1: https://lkml.org/lkml/2016/11/26/144
v2: https://lkml.org/lkml/2017/3/22/804
v3: https://lkml.org/lkml/2017/3/30/90
v4: https://lkml.org/lkml/2017/6/5/1005

Masahiro Yamada (18):
  mtd: nand: denali: set NAND_ECC_CUSTOM_PAGE_ACCESS
  mtd: nand: denali: remove unneeded find_valid_banks()
  mtd: nand: denali: handle timing parameters by setup_data_interface()
  mtd: nand: denali: rework interrupt handling
  mtd: nand: denali: fix NAND_CMD_STATUS handling
  mtd: nand: denali: fix NAND_CMD_PARAM handling
  mtd: nand: denali: switch over to cmd_ctrl instead of cmdfunc
  mtd: nand: denali: fix bank reset function to detect the number of
    chips
  mtd: nand: denali: use interrupt instead of polling for bank reset
  mtd: nand: denali: propagate page to helpers via function argument
  mtd: nand: denali: merge struct nand_buf into struct denali_nand_info
  mtd: nand: denali: use flag instead of register macro for direction
  mtd: nand: denali: fix raw and oob accessors for syndrome page layout
  mtd: nand: denali: support hardware-assisted erased page detection
  mtd: nand: denali: skip driver internal bounce buffer when possible
  mtd: nand: denali: use non-managed kmalloc() for DMA buffer
  mtd: nand: denali: enable bad block table scan
  mtd: nand: denali: avoid magic numbers and rename for clarification

 drivers/mtd/nand/denali.c     | 1715 ++++++++++++++++++-----------------------
 drivers/mtd/nand/denali.h     |   63 +-
 drivers/mtd/nand/denali_dt.c  |   15 +-
 drivers/mtd/nand/denali_pci.c |   22 +-
 4 files changed, 800 insertions(+), 1015 deletions(-)

-- 
2.7.4


______________________________________________________
Linux MTD discussion mailing list
http://lists.infradead.org/mailman/listinfo/linux-mtd/