@@ -54,6 +54,15 @@
#define MHZ(v) ((u32)((v) * 1000000U))
+/*
+ * If this is defined, the i2c addresses from UB960_DEBUG_I2C_RX_ID to
+ * UB960_DEBUG_I2C_RX_ID + 3 can be used to access the paged RX port registers
+ * directly.
+ *
+ * Only for debug purposes.
+ */
+/* #define UB960_DEBUG_I2C_RX_ID 0x40 */
+
#define UB960_POLL_TIME_MS 500
#define UB960_MAX_RX_NPORTS 4
@@ -350,7 +359,7 @@
#define UB960_SR_FPD3_RX_ID(n) (0xf0 + (n))
#define UB960_SR_FPD3_RX_ID_LEN 6
-#define UB960_SR_I2C_RX_ID(n) (0xf8 + (n)) /* < UB960_FPD_RX_NPORTS */
+#define UB960_SR_I2C_RX_ID(n) (0xf8 + (n))
#define UB9702_SR_REFCLK_FREQ 0x3d
@@ -4002,6 +4011,12 @@ static int ub960_probe(struct i2c_client *client)
schedule_delayed_work(&priv->poll_work,
msecs_to_jiffies(UB960_POLL_TIME_MS));
+#ifdef UB960_DEBUG_I2C_RX_ID
+ for (unsigned int i = 0; i < 4; ++i)
+ ub960_write(priv, UB960_SR_I2C_RX_ID(i),
+ (UB960_DEBUG_I2C_RX_ID + i) << 1);
+#endif
+
return 0;
err_free_sers:
Normally the driver accesses both the RX and the TX port registers via a paging mechanism: one register is used to select the page (i.e. the port), which dictates the port used when accessing the port specific registers. The downside to this is that while debugging it's almost impossible to access the port specific registers from the userspace, as the driver can change the page at any moment. The hardware supports another access mechanism: using the I2C_RX_ID registers (one for each RX port), i2c addresses can be chosen which, when accessed, will always use the specific port's registers, skipping the paging mechanism. The support is only for the RX port, but it has proven very handy while debugging and testing. So let's add the code for this, but hide it behind a disabled define. Signed-off-by: Tomi Valkeinen <tomi.valkeinen@ideasonboard.com> --- drivers/media/i2c/ds90ub960.c | 17 ++++++++++++++++- 1 file changed, 16 insertions(+), 1 deletion(-)