| Message ID | 20230814141007.3721197-9-bryan.odonoghue@linaro.org |
|---|---|
| State | New |
| Headers | show |
| Series | media: qcom: camss: Bugfix series | expand |
On 21/08/2023 10:53, Hans Verkuil wrote: > Hi Bryan, > > On 14/08/2023 16:10, Bryan O'Donoghue wrote: >> VC_MODE = 0 implies a two bit VC address. >> VC_MODE = 1 is required for VCs with a larger address than two bits. > > This explains the second chunk in the patch below, but it doesn't explain > why dt_id is now suddenly vc * 4 instead of vc. > > I don't feel comfortable merging this patch since I'm not sure if that > dt_id change was perhaps an error. > > If the change IS correct, then please reply and provide a better commit > log. From memory that's a copy/paste from the original qcom code. I'll verify that and repost a better commit log. --- bod
On 21/08/2023 10:53, Hans Verkuil wrote:
> + u8 dt_id = vc * 4;
You're right.
dt_id = vc is wrong but so is dt_id = vc * 4.
I'll post a fix for the dt_id as a separate patch.
---
bod
On 21/08/2023 19:51, Bryan O'Donoghue wrote: > On 21/08/2023 10:53, Hans Verkuil wrote: >> + u8 dt_id = vc * 4; > > You're right. > > dt_id = vc is wrong but so is dt_id = vc * 4. > > I'll post a fix for the dt_id as a separate patch. > > --- > bod No wait.. dt_id = vc is _fine_ I'll add a patch to document what this does since the provenance of the changes for this value are undocumented and confusing even to me, with access to the documentation for it. --- bod
diff --git a/drivers/media/platform/qcom/camss/camss-csid-gen2.c b/drivers/media/platform/qcom/camss/camss-csid-gen2.c index 45c7986d4a8d0..9ac253111e572 100644 --- a/drivers/media/platform/qcom/camss/camss-csid-gen2.c +++ b/drivers/media/platform/qcom/camss/camss-csid-gen2.c @@ -352,7 +352,7 @@ static void __csid_configure_stream(struct csid_device *csid, u8 enable, u8 vc) phy_sel = csid->phy.csiphy_id; if (enable) { - u8 dt_id = vc; + u8 dt_id = vc * 4; if (tg->enabled) { /* Config Test Generator */ @@ -449,6 +449,8 @@ static void __csid_configure_stream(struct csid_device *csid, u8 enable, u8 vc) writel_relaxed(val, csid->base + CSID_CSI2_RX_CFG0); val = 1 << CSI2_RX_CFG1_PACKET_ECC_CORRECTION_EN; + if (vc > 3) + val |= 1 << CSI2_RX_CFG1_VC_MODE; val |= 1 << CSI2_RX_CFG1_MISR_EN; writel_relaxed(val, csid->base + CSID_CSI2_RX_CFG1);
VC_MODE = 0 implies a two bit VC address. VC_MODE = 1 is required for VCs with a larger address than two bits. Fixes: eebe6d00e9bf ("media: camss: Add support for CSID hardware version Titan 170") Cc: stable@vger.kernel.org Signed-off-by: Bryan O'Donoghue <bryan.odonoghue@linaro.org> --- drivers/media/platform/qcom/camss/camss-csid-gen2.c | 4 +++- 1 file changed, 3 insertions(+), 1 deletion(-)