@@ -126,6 +126,7 @@ struct atomisp_input_subdev {
unsigned int type;
enum atomisp_camera_port port;
u32 code; /* MEDIA_BUS_FMT_* */
+ bool binning_support;
bool crop_support;
struct v4l2_subdev *camera;
/* Sensor rects for sensors which support crop */
@@ -934,11 +934,12 @@ static int atomisp_register_entities(struct atomisp_device *isp)
static void atomisp_init_sensor(struct atomisp_input_subdev *input)
{
struct v4l2_subdev_mbus_code_enum mbus_code_enum = { };
+ struct v4l2_subdev_frame_size_enum fse = { };
struct v4l2_subdev_state sd_state = {
.pads = &input->pad_cfg,
};
struct v4l2_subdev_selection sel = { };
- int err;
+ int i, err;
mbus_code_enum.which = V4L2_SUBDEV_FORMAT_ACTIVE;
err = v4l2_subdev_call(input->camera, pad, enum_mbus_code, NULL, &mbus_code_enum);
@@ -961,6 +962,28 @@ static void atomisp_init_sensor(struct atomisp_input_subdev *input)
input->active_rect = sel.r;
+ /*
+ * Check for a framesize with half active_rect width and height,
+ * if found assume the sensor supports binning.
+ * Do this before changing the crop-rect since that may influence
+ * enum_frame_size results.
+ */
+ for (i = 0; ; i++) {
+ fse.index = i;
+ fse.code = input->code;
+ fse.which = V4L2_SUBDEV_FORMAT_ACTIVE;
+
+ err = v4l2_subdev_call(input->camera, pad, enum_frame_size, NULL, &fse);
+ if (err)
+ break;
+
+ if (fse.min_width <= (input->active_rect.width / 2) &&
+ fse.min_height <= (input->active_rect.height / 2)) {
+ input->binning_support = true;
+ break;
+ }
+ }
+
/*
* The ISP also wants the non-active pixels at the border of the sensor
* for padding, set the crop rect to cover the entire sensor instead
@@ -983,9 +1006,10 @@ static void atomisp_init_sensor(struct atomisp_input_subdev *input)
if (err)
return;
- dev_info(input->camera->dev, "Supports crop native %dx%d active %dx%d\n",
+ dev_info(input->camera->dev, "Supports crop native %dx%d active %dx%d binning %d\n",
input->native_rect.width, input->native_rect.height,
- input->active_rect.width, input->active_rect.height);
+ input->active_rect.width, input->active_rect.height,
+ input->binning_support);
input->crop_support = true;
}
Make atomisp_init_sensor() check if the sensor supports binning. This is a preparation patch for using the selection / crop support to determine the padding values to use with a specific sensor. Signed-off-by: Hans de Goede <hdegoede@redhat.com> --- .../media/atomisp/pci/atomisp_internal.h | 1 + .../staging/media/atomisp/pci/atomisp_v4l2.c | 30 +++++++++++++++++-- 2 files changed, 28 insertions(+), 3 deletions(-)