@@ -1062,6 +1062,49 @@ csi: camera@1cb0000 {
clock-names = "bus", "mod", "ram";
resets = <&ccu RST_BUS_CSI>;
status = "disabled";
+
+ ports {
+ #address-cells = <1>;
+ #size-cells = <0>;
+
+ port@1 {
+ reg = <1>;
+
+ csi_in_mipi_csi2: endpoint {
+ remote-endpoint = <&mipi_csi2_out_csi>;
+ };
+ };
+ };
+ };
+
+ mipi_csi2: csi@1cb1000 {
+ compatible = "allwinner,sun8i-a83t-mipi-csi2";
+ reg = <0x01cb1000 0x1000>;
+ interrupts = <GIC_SPI 83 IRQ_TYPE_LEVEL_HIGH>;
+ clocks = <&ccu CLK_BUS_CSI>,
+ <&ccu CLK_CSI_SCLK>,
+ <&ccu CLK_MIPI_CSI>,
+ <&ccu CLK_CSI_MISC>;
+ clock-names = "bus", "mod", "mipi", "misc";
+ resets = <&ccu RST_BUS_CSI>;
+ status = "disabled";
+
+ ports {
+ #address-cells = <1>;
+ #size-cells = <0>;
+
+ mipi_csi2_in: port@0 {
+ reg = <0>;
+ };
+
+ mipi_csi2_out: port@1 {
+ reg = <1>;
+
+ mipi_csi2_out_csi: endpoint {
+ remote-endpoint = <&csi_in_mipi_csi2>;
+ };
+ };
+ };
};
hdmi: hdmi@1ee0000 {
MIPI CSI-2 is supported on the A83T with a dedicated controller that covers both the protocol and D-PHY. It is connected to the only CSI receiver with a fwnode graph link. Note that the CSI receiver supports both this MIPI CSI-2 source and a parallel source. An empty port with a label for the MIPI CSI-2 sensor input is also defined for convenience. Signed-off-by: Paul Kocialkowski <paul.kocialkowski@bootlin.com> --- arch/arm/boot/dts/sun8i-a83t.dtsi | 43 +++++++++++++++++++++++++++++++ 1 file changed, 43 insertions(+)