@@ -527,6 +527,7 @@ static int si2168_init(struct dvb_frontend *fe)
goto err;
dev->warm = true;
+ dev->initialized=true;
warm:
/* Init stats here to indicate which stats are supported */
c->cnr.len = 1;
@@ -548,6 +549,28 @@ static int si2168_init(struct dvb_frontend *fe)
return ret;
}
+static int si2168_resume(struct dvb_frontend *fe)
+{
+ struct i2c_client *client = fe->demodulator_priv;
+ struct si2168_dev *dev = i2c_get_clientdata(client);
+
+ /* check whether si2168_init() has been called successfully
+ * outside of a resume cycle. Ony call it (and load firmware)
+ * in this case. si2168_init() is only called during resume
+ * once the device has actually been used. Otherwise, leave the
+ * device untouched.
+ */
+ if(dev->initialized) {
+ dev_dbg(&client->dev, "previsously initialized, call si2168_init()\n");
+ return si2168_init(fe);
+ }
+ else {
+ dev_dbg(&client->dev, "not initialized yet, skipping init on resume\n");
+ return 0;
+ }
+}
+
+
static int si2168_sleep(struct dvb_frontend *fe)
{
struct i2c_client *client = fe->demodulator_priv;
@@ -657,6 +680,7 @@ static const struct dvb_frontend_ops si2168_ops = {
.init = si2168_init,
.sleep = si2168_sleep,
+ .resume = si2168_resume,
.set_frontend = si2168_set_frontend,
@@ -37,6 +37,7 @@ struct si2168_dev {
u8 ts_mode;
unsigned int active:1;
unsigned int warm:1;
+ unsigned int initialized:1;
unsigned int ts_clock_inv:1;
unsigned int ts_clock_gapped:1;
unsigned int spectral_inversion:1;
At connection time (or boot) in si2168_probe(), the firmware is not loaded to the device and the device is not fully activated. It is not useful or sensible to do this full initialization on resume in case it has not been previously initialized and is expected to be in this initialized state. Calling si2168_init() and therefore reading the firmware file for the first time during resume leads to problems and should be avoided. It is however safe to read the firmware file once it has already been read outside of a suspend/resume situation. Add a staus flag 'initialized' to store whether si2168_init() has successfully been called. If initialization fails (e.g. due to missing firmware file), the flag is not set. Register a separate si2168_resume callback which only calls si2168_init() once the 'initialized' flag has been set and it is safe to load the firmware at resume. The first call to si2168_init() will now always happen when the device is actually used for the first time and never during resume. This avoids the unsafe firmware file reading and should also speed up resume by skipping unnecessary device initialization. Signed-off-by: Lukas Middendorf <kernel@tuxforce.de> --- drivers/media/dvb-frontends/si2168.c | 24 +++++++++++++++++++++++ drivers/media/dvb-frontends/si2168_priv.h | 1 + 2 files changed, 25 insertions(+)