@@ -325,7 +325,6 @@ struct cal_ctx {
struct vb2_queue vb_vidq;
unsigned int index;
unsigned int cport;
- unsigned int virtual_channel;
/* Pointer pointing to current v4l2_buffer */
struct cal_buffer *cur_frm;
@@ -1035,8 +1034,7 @@ static void cal_ctx_csi2_config(struct cal_ctx *ctx)
* 0x1E: YUV422 2 pixels = 4 bytes
*/
set_field(&val, 0x1, CAL_CSI2_CTX_DT_MASK);
- /* Virtual Channel from the CSI2 sensor usually 0! */
- set_field(&val, ctx->virtual_channel, CAL_CSI2_CTX_VC_MASK);
+ set_field(&val, 0, CAL_CSI2_CTX_VC_MASK);
set_field(&val, ctx->v_fmt.fmt.pix.height, CAL_CSI2_CTX_LINES_MASK);
set_field(&val, CAL_CSI2_CTX_ATT_PIX, CAL_CSI2_CTX_ATT_MASK);
set_field(&val, CAL_CSI2_CTX_PACK_MODE_LINE,
@@ -2140,11 +2138,7 @@ static int of_cal_create_instance(struct cal_ctx *ctx, int inst)
goto cleanup_exit;
}
- /* Store Virtual Channel number */
- ctx->virtual_channel = endpoint->base.id;
-
ctx_dbg(3, ctx, "Port:%d v4l2-endpoint: CSI2\n", inst);
- ctx_dbg(3, ctx, "Virtual Channel=%d\n", ctx->virtual_channel);
ctx_dbg(3, ctx, "flags=0x%08x\n", endpoint->bus.mipi_csi2.flags);
ctx_dbg(3, ctx, "clock_lane=%d\n", endpoint->bus.mipi_csi2.clock_lane);
ctx_dbg(3, ctx, "num_data_lanes=%d\n",
Using the endpoint reg value to pass the CSI-2 source virtual channel ID in DT is a hack, isn't documented in the DT bindings, and isn't used in neither upstream DT nor TI official overlays. Hardcode the virtual channel to 0 to simplify reworking the code, proper virtual channel support will be implemented later. Signed-off-by: Laurent Pinchart <laurent.pinchart@ideasonboard.com> --- drivers/media/platform/ti-vpe/cal.c | 8 +------- 1 file changed, 1 insertion(+), 7 deletions(-)