@@ -30,6 +30,7 @@
* 0x40 engine 2 muxing info
* 0x50 engine 3 muxing info
*/
+#define LP5523_PAGES_PER_ENGINE 1
#define LP5523_MAX_LEDS 9
/* Registers */
@@ -159,20 +160,6 @@ static int lp5523_post_init_device(struct lp55xx_chip *chip)
return lp5523_init_program_engine(chip);
}
-static void lp5523_load_engine_and_select_page(struct lp55xx_chip *chip)
-{
- enum lp55xx_engine_index idx = chip->engine_idx;
- static const u8 page_sel[] = {
- [LP55XX_ENGINE_1] = LP5523_PAGE_ENG1,
- [LP55XX_ENGINE_2] = LP5523_PAGE_ENG2,
- [LP55XX_ENGINE_3] = LP5523_PAGE_ENG3,
- };
-
- lp55xx_load_engine(chip);
-
- lp55xx_write(chip, LP5523_REG_PROG_PAGE_SEL, page_sel[idx]);
-}
-
static void lp5523_stop_engine(struct lp55xx_chip *chip)
{
enum lp55xx_engine_index idx = chip->engine_idx;
@@ -272,7 +259,7 @@ static int lp5523_init_program_engine(struct lp55xx_chip *chip)
/* write LED MUX address space for each engine */
for (i = LP55XX_ENGINE_1; i <= LP55XX_ENGINE_3; i++) {
chip->engine_idx = i;
- lp5523_load_engine_and_select_page(chip);
+ lp55xx_load_engine(chip);
for (j = 0; j < LP5523_PROGRAM_LENGTH; j++) {
ret = lp55xx_write(chip, LP5523_REG_PROG_MEM + j,
@@ -362,7 +349,7 @@ static void lp5523_firmware_loaded(struct lp55xx_chip *chip)
* 2) write firmware data into program memory
*/
- lp5523_load_engine_and_select_page(chip);
+ lp55xx_load_engine(chip);
lp5523_update_program_memory(chip, fw->data, fw->size);
}
@@ -544,7 +531,7 @@ static ssize_t store_engine_load(struct device *dev,
mutex_lock(&chip->lock);
chip->engine_idx = nr;
- lp5523_load_engine_and_select_page(chip);
+ lp55xx_load_engine(chip);
ret = lp5523_update_program_memory(chip, buf, len);
mutex_unlock(&chip->lock);
@@ -865,6 +852,7 @@ static struct lp55xx_device_config lp5523_cfg = {
.addr = LP5523_REG_ENABLE,
.val = LP5523_ENABLE,
},
+ .pages_per_engine = LP5523_PAGES_PER_ENGINE,
.max_channel = LP5523_MAX_LEDS,
.post_init_device = lp5523_post_init_device,
.brightness_fn = lp5523_led_brightness,
@@ -46,6 +46,11 @@
#define LP55xx_MODE_ENGn_GET(n, mode, shift) \
(((mode) >> LP55xx_MODE_ENGn_SHIFT(n, shift)) & LP55xx_MODE_ENG_MASK)
+/* Memory Page Selection */
+#define LP55xx_REG_PROG_PAGE_SEL 0x4f
+/* If supported, each ENGINE have an equal amount of pages offset from page 0 */
+#define LP55xx_PAGE_OFFSET(n, pages) (((n) - 1) * (pages))
+
/* External clock rate */
#define LP55XX_CLK_32K 32768
@@ -104,6 +109,11 @@ void lp55xx_load_engine(struct lp55xx_chip *chip)
lp55xx_update_bits(chip, cfg->reg_op_mode.addr, mask, val);
lp55xx_wait_opmode_done(chip);
+
+ /* Setup PAGE if supported (pages_per_engine not 0)*/
+ if (cfg->pages_per_engine)
+ lp55xx_write(chip, LP55xx_REG_PROG_PAGE_SEL,
+ LP55xx_PAGE_OFFSET(idx, cfg->pages_per_engine));
}
EXPORT_SYMBOL_GPL(lp55xx_load_engine);
@@ -99,6 +99,8 @@ struct lp55xx_reg {
* (if not supported 153 us sleep)
* @reset : Chip specific reset command
* @enable : Chip specific enable command
+ * @pages_per_engine : Assigned pages for each engine
+ * (if not set chip doesn't support pages)
* @max_channel : Maximum number of channels
* @post_init_device : Chip specific initialization code
* @brightness_fn : Brightness function
@@ -113,6 +115,7 @@ struct lp55xx_device_config {
const struct lp55xx_reg engine_busy; /* addr, mask */
const struct lp55xx_reg reset;
const struct lp55xx_reg enable;
+ const int pages_per_engine;
const int max_channel;
/* define if the device has specific initialization process */
@@ -21,6 +21,7 @@
#include "leds-lp55xx-common.h"
#define LP8501_PROGRAM_LENGTH 32
+#define LP8501_PAGES_PER_ENGINE 1
#define LP8501_MAX_LEDS 9
/* Registers */
@@ -116,21 +117,6 @@ static int lp8501_post_init_device(struct lp55xx_chip *chip)
LP8501_PWR_CONFIG_M, chip->pdata->pwr_sel);
}
-static void lp8501_load_engine(struct lp55xx_chip *chip)
-{
- enum lp55xx_engine_index idx = chip->engine_idx;
-
- static const u8 page_sel[] = {
- [LP55XX_ENGINE_1] = LP8501_PAGE_ENG1,
- [LP55XX_ENGINE_2] = LP8501_PAGE_ENG2,
- [LP55XX_ENGINE_3] = LP8501_PAGE_ENG3,
- };
-
- lp55xx_load_engine(chip);
-
- lp55xx_write(chip, LP8501_REG_PROG_PAGE_SEL, page_sel[idx]);
-}
-
static void lp8501_turn_off_channels(struct lp55xx_chip *chip)
{
int i;
@@ -250,7 +236,7 @@ static void lp8501_firmware_loaded(struct lp55xx_chip *chip)
* 2) write firmware data into program memory
*/
- lp8501_load_engine(chip);
+ lp55xx_load_engine(chip);
lp8501_update_program_memory(chip, fw->data, fw->size);
}
@@ -284,6 +270,7 @@ static struct lp55xx_device_config lp8501_cfg = {
.addr = LP8501_REG_ENABLE,
.val = LP8501_ENABLE,
},
+ .pages_per_engine = LP8501_PAGES_PER_ENGINE,
.max_channel = LP8501_MAX_LEDS,
.post_init_device = lp8501_post_init_device,
.brightness_fn = lp8501_led_brightness,
Generalize load_engine_and_select_page by reworking the implementation and making it part of the generic load_engine function. Add a new option in device_config, pages_per_engine used to define pages assigned to each engine. With this option set, it's assumed LED chip supports pages and load_engine will correctly setup the write page. An equal amount of pages is assigned to each engine and they are assigned from page 0. Update any lp55xx based LED driver to define the option and use the new function. Suggested-by: Lee Jones <lee@kernel.org> Signed-off-by: Christian Marangi <ansuelsmth@gmail.com> --- drivers/leds/leds-lp5523.c | 22 +++++----------------- drivers/leds/leds-lp55xx-common.c | 10 ++++++++++ drivers/leds/leds-lp55xx-common.h | 3 +++ drivers/leds/leds-lp8501.c | 19 +++---------------- 4 files changed, 21 insertions(+), 33 deletions(-)