@@ -52,16 +52,16 @@ enum thc_int_type {
* struct thc_device - THC private device struct
* @thc_regmap: MMIO regmap structure for accessing THC registers
* @mmio_addr: MMIO registers address
- * @thc_bus_lock: mutex locker for THC config
- * @port_type: port type of THC port instance
+ * @thc_bus_lock: Mutex locker for THC config
+ * @port_type: Port type of THC port instance
* @pio_int_supported: PIO interrupt supported flag
* @dma_ctx: DMA specific data
- * @write_complete_wait: signal event for DMA write complete
- * @swdma_complete_wait: signal event for SWDMA sequence complete
- * @write_done: bool value that indicates if DMA write is done
- * @swdma_done: bool value that indicates if SWDMA swquence is done
- * @perf_limit: the delay between read operation and write operation
- * @i2c_subip_regs: the copy of THC I2C sub-system registers for resuming restore
+ * @write_complete_wait: Signal event for DMA write complete
+ * @swdma_complete_wait: Signal event for SWDMA sequence complete
+ * @write_done: Bool value that indicates if DMA write is done
+ * @swdma_done: Bool value that indicates if SWDMA sequence is done
+ * @perf_limit: The delay between read operation and write operation
+ * @i2c_subip_regs: The copy of THC I2C sub-system registers for resuming restore
*/
struct thc_device {
struct device *dev;
@@ -27,7 +27,7 @@
/**
* THC DMA channels:
- * @THC_RXDMA1: legacy channel, reserved for raw data reading
+ * @THC_RXDMA1: Legacy channel, reserved for raw data reading
* @THC_RXDMA2: DMA to read HID data from touch device
* @THC_TXDMA: DMA to write to touch device
* @THC_SWDMA: SW triggered DMA to write and read from touch device
@@ -42,11 +42,11 @@ enum thc_dma_channel {
/**
* THC DMA Physical Memory Descriptor (PRD)
- * @dest_addr: bit[53:0], destination address in system memory
- * @int_on_completion: bit[63], if set, thc will trigger interrupt to driver
- * @len: bit[87:64], length of this entry
- * @end_of_prd: bit[88], if set, this entry is last one of current PRD table
- * @hw_status: bit[90:89], hw status bits
+ * @dest_addr: Bit[53:0], destination address in system memory
+ * @int_on_completion: Bit[63], if set, thc will trigger interrupt to driver
+ * @len: Bit[87:64], length of this entry
+ * @end_of_prd: Bit[88], if set, this entry is last one of current PRD table
+ * @hw_status: Bit[90:89], hardware status bits
*/
struct thc_prd_entry {
u64 dest_addr : 54;
@@ -88,14 +88,14 @@ struct thc_prd_table {
* struct thc_dma_configuration - THC DMA configure
* @dma_channel: DMA channel for current DMA configuration
* @prd_tbls_dma_handle: DMA buffer handle
- * @dir: direction of DMA for this config
+ * @dir: Direction of DMA for this config
* @prd_tbls: PRD tables for current DMA
- * @sgls: array of pointers to scatter-gather lists
- * @sgls_nent: actual number of entries per sg list
- * @prd_tbl_num: actual number of PRD tables
- * @max_packet_size: size of the buffer needed for 1 DMA message (1 PRD table)
+ * @sgls: Array of pointers to scatter-gather lists
+ * @sgls_nent: Actual number of entries per scatter-gather list
+ * @prd_tbl_num: Actual number of PRD tables
+ * @max_packet_size: Size of the buffer needed for 1 DMA message (1 PRD table)
* @prd_base_addr_high: High 32bits memory address where stores PRD table
- * @prd_base_addr_low: low 32bits memory address where stores PRD table
+ * @prd_base_addr_low: Low 32bits memory address where stores PRD table
* @prd_cntrl: PRD control register value
* @dma_cntrl: DMA control register value
*/
Align capitalization of the first characters for THC structure definition comments in header files. Signed-off-by: Even Xu <even.xu@intel.com> --- .../intel-thc-hid/intel-thc/intel-thc-dev.h | 16 ++++++------- .../intel-thc-hid/intel-thc/intel-thc-dma.h | 24 +++++++++---------- 2 files changed, 20 insertions(+), 20 deletions(-)