diff mbox series

[v3,11/34] dt-bindings: pinctrl: qcom,ipq6018: fix matching pin config

Message ID 20220927173702.5200-12-krzysztof.kozlowski@linaro.org
State Superseded
Headers show
Series pinctrl/arm64: qcom: continued - fix Qualcomm TLMM pinctrl schema warnings | expand

Commit Message

Krzysztof Kozlowski Sept. 27, 2022, 5:36 p.m. UTC 
The TLMM pin controller follows generic pin-controller bindings, so
should have subnodes with '-state' and '-pins'.  Otherwise the subnodes
(level one and two) are not properly matched.  This method also unifies
the bindings with other Qualcomm TLMM and LPASS pinctrl bindings.

Signed-off-by: Krzysztof Kozlowski <krzysztof.kozlowski@linaro.org>
Reviewed-by: Bjorn Andersson <andersson@kernel.org>
---
 .../bindings/pinctrl/qcom,ipq6018-pinctrl.yaml    | 15 +++++++++++----
 1 file changed, 11 insertions(+), 4 deletions(-)
diff mbox series

Patch

diff --git a/Documentation/devicetree/bindings/pinctrl/qcom,ipq6018-pinctrl.yaml b/Documentation/devicetree/bindings/pinctrl/qcom,ipq6018-pinctrl.yaml
index 7202e2af200b..735a8786cb13 100644
--- a/Documentation/devicetree/bindings/pinctrl/qcom,ipq6018-pinctrl.yaml
+++ b/Documentation/devicetree/bindings/pinctrl/qcom,ipq6018-pinctrl.yaml
@@ -42,10 +42,17 @@  properties:
   gpio-ranges:
     maxItems: 1
 
-#PIN CONFIGURATION NODES
 patternProperties:
-  '-pinmux$':
-    type: object
+  "-state$":
+    oneOf:
+      - $ref: "#/$defs/qcom-ipq6018-tlmm-state"
+      - patternProperties:
+          "-pins$":
+            $ref: "#/$defs/qcom-ipq6018-tlmm-state"
+        additionalProperties: false
+
+$defs:
+  qcom-ipq6018-tlmm-state:
     description:
       Pinctrl node's client devices use subnodes for desired pin configuration.
       Client device subnodes use below standard properties.
@@ -146,7 +153,7 @@  examples:
               #gpio-cells = <2>;
               gpio-ranges = <&tlmm 0 0 80>;
 
-              serial3-pinmux {
+              serial3-state {
                       pins = "gpio44", "gpio45";
                       function = "blsp2_uart";
                       drive-strength = <8>;