mbox series

[v3,0/4] Add support for NetCube Systems Kumquat

Message ID 20250103204523.3779-1-lukas.schmid@netcube.li
Headers show
Series Add support for NetCube Systems Kumquat | expand

Message

Lukas Schmid Jan. 3, 2025, 8:45 p.m. UTC 
This series adds dt-bindings and dts for the NetCube Systems Kumquat board.

Changes in v2:
  Fix the devicetrees according to the "dt-schema" and "make dtbs_check W=1"
  Fix the License of the devicetree as requested
  Create a cover letter for the patch series

Changes in v3:
  Disable rtc inside the SoC again, as the rtc does not work
  Add the gpio-reserved-ranges property to the pinctrl bindings
  Reorder the nodes in the devicetree to match the order of the nodes in the
  sun8i-v3s.dtsi file

Signed-off-by: Lukas Schmid <lukas.schmid@netcube.li>
---
Lukas Schmid (4):
  dt-bindings: vendor-prefixes: Add NetCube Systems Austria name
  dt-bindings: arm: sunxi: Add NetCube Systems Kumquat board
  dt-bindings: pinctrl: sunxi: Add gpio-reserved-ranges property
  ARM: dts: sunxi: add support for NetCube Systems Kumquat

 .../devicetree/bindings/arm/sunxi.yaml        |   5 +
 .../pinctrl/allwinner,sun4i-a10-pinctrl.yaml  |   5 +
 .../devicetree/bindings/vendor-prefixes.yaml  |   2 +
 arch/arm/boot/dts/allwinner/Makefile          |   2 +
 .../allwinner/sun8i-v3s-netcube-kumquat.dts   | 290 ++++++++++++++++++
 arch/arm/boot/dts/allwinner/sun8i-v3s.dtsi    |   6 +
 6 files changed, 310 insertions(+)
 create mode 100644 arch/arm/boot/dts/allwinner/sun8i-v3s-netcube-kumquat.dts