@@ -22,6 +22,49 @@
.code64
.text
+/*
+ * When booting in 64-bit mode on 32-bit EFI firmware, startup_64_mixed_mode()
+ * is the first thing that runs after switching to long mode. Depending on
+ * whether the EFI handover protocol or the compat entry point was used to
+ * enter the kernel, it will either branch to the 64-bit EFI handover
+ * entrypoint at offset 0x390 in the image, or to the 64-bit EFI PE/COFF
+ * entrypoint efi_pe_entry(). In the former case, the bootloader must provide a
+ * struct bootparams pointer as the third argument, so the presence of such a
+ * pointer is used to disambiguate.
+ *
+ * +--------------+
+ * +------------------+ +------------+ +------>| efi_pe_entry |
+ * | efi32_pe_entry |---->| | | +-----------+--+
+ * +------------------+ | | +------+----------------+ |
+ * | startup_32 |---->| startup_64_mixed_mode | |
+ * +------------------+ | | +------+----------------+ V
+ * | efi32_stub_entry |---->| | | +------------------+
+ * +------------------+ +------------+ +---->| efi64_stub_entry |
+ * +-------------+----+
+ * +------------+ +----------+ |
+ * | startup_64 |<----| efi_main |<--------------+
+ * +------------+ +----------+
+ */
+SYM_FUNC_START(startup_64_mixed_mode)
+ lea efi32_boot_args(%rip), %rdx
+ mov 0(%rdx), %edi
+ mov 4(%rdx), %esi
+ mov 8(%rdx), %edx // saved bootparams pointer
+ test %edx, %edx
+ jnz efi64_stub_entry
+ /*
+ * efi_pe_entry uses MS calling convention, which requires 32 bytes of
+ * shadow space on the stack even if all arguments are passed in
+ * registers. We also need an additional 8 bytes for the space that
+ * would be occupied by the return address, and this also results in
+ * the correct stack alignment for entry.
+ */
+ sub $40, %rsp
+ mov %rdi, %rcx // MS calling convention
+ mov %rsi, %rdx
+ jmp efi_pe_entry
+SYM_FUNC_END(startup_64_mixed_mode)
+
SYM_FUNC_START(__efi64_thunk)
push %rbp
push %rbx
@@ -269,25 +269,9 @@ SYM_FUNC_START(startup_32)
*/
leal rva(startup_64)(%ebp), %eax
#ifdef CONFIG_EFI_MIXED
- movl rva(efi32_boot_args)(%ebp), %edi
- testl %edi, %edi
- jz 1f
- leal rva(efi64_stub_entry)(%ebp), %eax
- movl rva(efi32_boot_args+4)(%ebp), %esi
- movl rva(efi32_boot_args+8)(%ebp), %edx // saved bootparams pointer
- testl %edx, %edx
- jnz 1f
- /*
- * efi_pe_entry uses MS calling convention, which requires 32 bytes of
- * shadow space on the stack even if all arguments are passed in
- * registers. We also need an additional 8 bytes for the space that
- * would be occupied by the return address, and this also results in
- * the correct stack alignment for entry.
- */
- subl $40, %esp
- leal rva(efi_pe_entry)(%ebp), %eax
- movl %edi, %ecx // MS calling convention
- movl %esi, %edx
+ cmpb $1, rva(efi_is64)(%ebp)
+ je 1f
+ leal rva(startup_64_mixed_mode)(%ebp), %eax
1:
#endif
/* Check if the C-bit position is correct when SEV is active */
@@ -787,7 +771,7 @@ SYM_DATA_END_LABEL(boot32_idt, SYM_L_GLOBAL, boot32_idt_end)
SYM_DATA(image_offset, .long 0)
#endif
#ifdef CONFIG_EFI_MIXED
-SYM_DATA_LOCAL(efi32_boot_args, .long 0, 0, 0)
+SYM_DATA(efi32_boot_args, .long 0, 0, 0)
SYM_DATA(efi_is64, .byte 1)
#define ST32_boottime 60 // offsetof(efi_system_table_32_t, boottime)
Move the logic that chooses between the different EFI entrypoints out of the 32-bit boot path, and into a 64-bit helper that can perform the same task much more cleanly. While at it, document the mixed mode boot flow in a code comment. Signed-off-by: Ard Biesheuvel <ardb@kernel.org> --- arch/x86/boot/compressed/efi_mixed.S | 43 ++++++++++++++++++++ arch/x86/boot/compressed/head_64.S | 24 ++--------- 2 files changed, 47 insertions(+), 20 deletions(-)