@@ -270,8 +270,8 @@ nand@0 {
};
&remoteproc_mpss {
- status = "okay";
memory-region = <&mpss_adsp_mem>;
+ status = "okay";
};
&usb {
@@ -283,14 +283,14 @@ &usb_dwc3 {
};
&usb_hsphy {
- status = "okay";
vdda-pll-supply = <&vreg_l4b_0p88>;
vdda33-supply = <&vreg_l10b_3p08>;
vdda18-supply = <&vreg_l5b_1p8>;
+ status = "okay";
};
&usb_qmpphy {
- status = "okay";
vdda-phy-supply = <&vreg_l4b_0p88>;
vdda-pll-supply = <&vreg_l1b_1p2>;
+ status = "okay";
};
@@ -224,16 +224,15 @@ usb_hsphy: phy@ff4000 {
"qcom,usb-snps-hs-7nm-phy";
reg = <0xff4000 0x120>;
#phy-cells = <0>;
- status = "disabled";
clocks = <&rpmhcc RPMH_CXO_CLK>;
clock-names = "ref";
resets = <&gcc GCC_QUSB2PHY_BCR>;
+ status = "disabled";
};
usb_qmpphy: phy@ff6000 {
compatible = "qcom,sdx65-qmp-usb3-uni-phy";
reg = <0x00ff6000 0x1c8>;
- status = "disabled";
#address-cells = <1>;
#size-cells = <1>;
ranges;
@@ -247,6 +246,8 @@ usb_qmpphy: phy@ff6000 {
<&gcc GCC_USB3_PHY_BCR>;
reset-names = "phy", "common";
+ status = "disabled";
+
usb_ssphy: phy@ff6200 {
reg = <0x00ff6e00 0x160>,
<0x00ff7000 0x1ec>,
@@ -393,7 +394,6 @@ mem_noc: interconnect@9680000 {
usb: usb@a6f8800 {
compatible = "qcom,sdx65-dwc3", "qcom,dwc3";
reg = <0x0a6f8800 0x400>;
- status = "disabled";
#address-cells = <1>;
#size-cells = <1>;
ranges;
@@ -423,6 +423,8 @@ usb: usb@a6f8800 {
resets = <&gcc GCC_USB30_BCR>;
+ status = "disabled";
+
usb_dwc3: usb@a600000 {
compatible = "snps,dwc3";
reg = <0x0a600000 0xcd00>;
Move a few device tree "status" properties so that they are the last specified property, in "qcom-sdx65-mtp.dts" and "qcom-sdx65.dtsi". Note that properties must always be specified before sub-nodes. Suggested-by: Konrad Dybcio <konrad.dybcio@linaro.org> Signed-off-by: Alex Elder <elder@linaro.org> --- arch/arm/boot/dts/qcom-sdx65-mtp.dts | 6 +++--- arch/arm/boot/dts/qcom-sdx65.dtsi | 8 +++++--- 2 files changed, 8 insertions(+), 6 deletions(-)