@@ -99,3 +99,7 @@ &usb0 {
&usb1 {
status = "okay";
};
+
+&ahci {
+ status = "okay";
+};
@@ -599,6 +599,46 @@ mdio: mdio {
};
};
+ ahci: ahci@65600000 {
+ compatible = "socionext,uniphier-pxs2-ahci",
+ "generic-ahci";
+ status = "disabled";
+ reg = <0x65600000 0x10000>;
+ interrupts = <GIC_SPI 142 IRQ_TYPE_LEVEL_HIGH>;
+ clocks = <&sys_clk 28>;
+ resets = <&sys_rst 28>, <&ahci_rst 0>;
+ ports-implemented = <1>;
+ phys = <&ahci_phy>;
+ };
+
+ ahci-glue@65700000 {
+ compatible = "socionext,uniphier-pxs2-ahci-glue",
+ "simple-mfd";
+ #address-cells = <1>;
+ #size-cells = <1>;
+ ranges = <0 0x65700000 0x100>;
+
+ ahci_rst: reset@0 {
+ compatible = "socionext,uniphier-pxs2-ahci-reset";
+ reg = <0x0 0x4>;
+ clock-names = "link";
+ clocks = <&sys_clk 28>;
+ reset-names = "link";
+ resets = <&sys_rst 28>;
+ #reset-cells = <1>;
+ };
+
+ ahci_phy: phy@10 {
+ compatible = "socionext,uniphier-pxs2-ahci-phy";
+ reg = <0x10 0x10>;
+ clock-names = "link";
+ clocks = <&sys_clk 28>;
+ reset-names = "link", "phy";
+ resets = <&sys_rst 28>, <&sys_rst 30>;
+ #phy-cells = <0>;
+ };
+ };
+
usb0: usb@65a00000 {
compatible = "socionext,uniphier-dwc3", "snps,dwc3";
status = "disabled";
Add ahci controller and glue layer nodes including reset and phy. This supports for PXs2 and the boards without PXs2 vodka board that doesn't implement any SATA connectors. Signed-off-by: Kunihiko Hayashi <hayashi.kunihiko@socionext.com> --- arch/arm/boot/dts/uniphier-pxs2-gentil.dts | 4 +++ arch/arm/boot/dts/uniphier-pxs2.dtsi | 40 ++++++++++++++++++++++ 2 files changed, 44 insertions(+)