mbox series

[0/3] Fixes for RGB30

Message ID 20231018153357.343142-1-macroalpha82@gmail.com
Headers show
Series Fixes for RGB30 | expand

Message

Chris Morgan Oct. 18, 2023, 3:33 p.m. UTC
From: Chris Morgan <macromorgan@hotmail.com>

After preliminary testing, a few users requested that I see if I can
make the panel run at precisely 60hz. As the device is typically used
for retro gaming, getting the panel to refresh as close to 60hz as
possible is important.

Additionally, I accidentially left the UART2 enabled, even though this
device does not have an exposed serial port on the board. Disable the
UART in the device tree.

This patch series applies on top of the already applied commit here:
https://git.kernel.org/pub/scm/linux/kernel/git/mmind/linux-rockchip.git/commit/?h=for-next&id=1e9ac3e8a6a9d4da9efbad2d8e95cc1140e0e23f

Chris Morgan (3):
  clk: rockchip: rk3568: Add PLL rate for 292.5MHz
  arm64: dts: rockchip: Update VPLL Frequency for RGB30
  arm64: dts: rockchip: Remove UART2 from RGB30

 .../arm64/boot/dts/rockchip/rk3566-powkiddy-rgb30.dts | 11 ++++++++++-
 drivers/clk/rockchip/clk-rk3568.c                     |  1 +
 2 files changed, 11 insertions(+), 1 deletion(-)

Comments

Heiko Stübner Oct. 19, 2023, 8:54 a.m. UTC | #1
On Wed, 18 Oct 2023 10:33:54 -0500, Chris Morgan wrote:
> From: Chris Morgan <macromorgan@hotmail.com>
> 
> After preliminary testing, a few users requested that I see if I can
> make the panel run at precisely 60hz. As the device is typically used
> for retro gaming, getting the panel to refresh as close to 60hz as
> possible is important.
> 
> [...]

Applied, thanks!

[1/3] clk: rockchip: rk3568: Add PLL rate for 292.5MHz
      commit: bb8ab7335bd2f55706fd09f5ce431207a746d99a
[2/3] arm64: dts: rockchip: Update VPLL Frequency for RGB30
      commit: 793e0d8988bc0e6bf2ff5c6df7fc81ec8c53a93e
[3/3] arm64: dts: rockchip: Remove UART2 from RGB30
      commit: efa1d1c6c8e4f89eedef9035d1f74fe98861eb30

Best regards,