@@ -46,6 +46,18 @@ other_ext_region@0 {
};
};
+ backlight: gpio-backlight {
+ compatible = "gpio-backlight";
+
+ gpios = <&tlmm 16 GPIO_ACTIVE_HIGH>;
+
+ default-on;
+
+ pinctrl-names = "default";
+ pinctrl-0 = <&backlight_enable_active>;
+ pinctrl-1 = <&backlight_enable_sleep>;
+ };
+
gpio-keys {
compatible = "gpio-keys";
key-volume-up {
@@ -63,6 +75,49 @@ vph_pwr: vph-pwr-regulator {
};
};
+&mdss {
+ status = "okay";
+};
+
+&mdss_dsi0 {
+ vdda-supply = <&pm8953_s3>;
+ vddio-supply = <&pm8953_l6>;
+
+ status = "okay";
+
+ panel@0 {
+ compatible = "boe,tv101wum-ll2";
+ reg = <0>;
+
+ vsp-supply = <&lab>;
+ vsn-supply = <&ibb>;
+ reset-gpios = <&tlmm 61 GPIO_ACTIVE_LOW>;
+
+ backlight = <&backlight>;
+
+ pinctrl-names = "default";
+ pinctrl-0 = <&panel_reset_active>;
+ pinctrl-1 = <&panel_reset_sleep>;
+
+ port {
+ panel_in: endpoint {
+ remote-endpoint = <&mdss_dsi0_out>;
+ };
+ };
+ };
+};
+
+&mdss_dsi0_out {
+ remote-endpoint = <&panel_in>;
+ data-lanes = <0 1 2 3>;
+};
+
+&mdss_dsi0_phy {
+ vcca-supply = <&pm8953_l3>;
+
+ status = "okay";
+};
+
&hsusb_phy {
vdd-supply = <&pm8953_l3>;
vdda-pll-supply = <&pm8953_l7>;
@@ -90,6 +145,18 @@ touchscreen@38 {
};
};
+&ibb {
+ regulator-min-microvolt = <4600000>;
+ regulator-max-microvolt = <6000000>;
+ qcom,discharge-resistor-kohms = <32>;
+};
+
+&lab {
+ regulator-min-microvolt = <4600000>;
+ regulator-max-microvolt = <6000000>;
+ qcom,soft-start-us = <800>;
+};
+
&pm8953_resin {
linux,code = <KEY_VOLUMEDOWN>;
status = "okay";
@@ -237,6 +304,36 @@ &sdhc_2 {
&tlmm {
gpio-reserved-ranges = <0 4>, <135 4>;
+ backlight_enable_active: backlight-enable-active-state {
+ pins = "gpio16";
+ function = "gpio";
+ drive-strength = <8>;
+ bias-disable;
+ output-high;
+ };
+
+ backlight_enable_sleep: backlight-enable-sleep-state {
+ pins = "gpio16";
+ function = "gpio";
+ drive-strength = <2>;
+ bias-pull-down;
+ };
+
+ panel_reset_active: panel-reset-active-state {
+ pins = "gpio61";
+ function = "gpio";
+ drive-strength = <8>;
+ bias-disable;
+ output-high;
+ };
+
+ panel_reset_sleep: panel-reset-sleep-state {
+ pins = "gpio61";
+ function = "gpio";
+ drive-strength = <2>;
+ bias-pull-down;
+ };
+
ts_int_active: ts-int-active-state {
pins = "gpio65";
function = "gpio";
Add the necessary nodes to enable the DSI panel on the Lenovo Smart Tab M10 tablet. Signed-off-by: Neil Armstrong <neil.armstrong@linaro.org> --- arch/arm64/boot/dts/qcom/sdm450-lenovo-tbx605f.dts | 97 ++++++++++++++++++++++ 1 file changed, 97 insertions(+)