@@ -1356,8 +1356,8 @@ &usb_1_dwc3 {
usb-role-switch;
};
-&usb_1_role_switch_out {
- remote-endpoint = <&pm8150b_role_switch_in>;
+&usb_1_dwc3_hs_out {
+ remote-endpoint = <&pm8150b_hs_in>;
};
&usb_1_hsphy {
@@ -1465,8 +1465,8 @@ ports {
port@0 {
reg = <0>;
- pm8150b_role_switch_in: endpoint {
- remote-endpoint = <&usb_1_role_switch_out>;
+ pm8150b_hs_in: endpoint {
+ remote-endpoint = <&usb_1_dwc3_hs_out>;
};
};
@@ -652,8 +652,8 @@ ports {
port@0 {
reg = <0>;
- pm8150b_role_switch_in: endpoint {
- remote-endpoint = <&usb_1_role_switch_out>;
+ pm8150b_hs_in: endpoint {
+ remote-endpoint = <&usb_1_dwc3_hs_out>;
};
};
};
@@ -716,8 +716,8 @@ &usb_1_hsphy {
status = "okay";
};
-&usb_1_role_switch_out {
- remote-endpoint = <&pm8150b_role_switch_in>;
+&usb_1_dwc3_hs_out {
+ remote-endpoint = <&pm8150b_hs_in>;
};
&ufs_mem_hc {
@@ -4196,7 +4196,7 @@ usb_1_dwc3: usb@a600000 {
phy-names = "usb2-phy", "usb3-phy";
port {
- usb_1_role_switch_out: endpoint {};
+ usb_1_dwc3_hs_out: endpoint {};
};
};
};
The OF graph should describe physical signals. There is no 'role switch' signal between Type-C connector and the DWC3 USB controller. Instead there is a HighSpeed signal lane between DWC3 controller and the USB-C connector. Rename endpoints in accordance to that (this follows the example lead by other plaforms, including QRB2210 RB1, QRB4210 RB2 and all PMIC GLINK platforms). Signed-off-by: Dmitry Baryshkov <dmitry.baryshkov@linaro.org> --- arch/arm64/boot/dts/qcom/qrb5165-rb5.dts | 8 ++++---- arch/arm64/boot/dts/qcom/sm8250-xiaomi-elish-common.dtsi | 8 ++++---- arch/arm64/boot/dts/qcom/sm8250.dtsi | 2 +- 3 files changed, 9 insertions(+), 9 deletions(-)