@@ -164,7 +164,8 @@ pm6125_l4: l4 {
pm6125_l5: l5 {
regulator-min-microvolt = <1650000>;
- regulator-max-microvolt = <3050000>;
+ regulator-max-microvolt = <2960000>;
+ regulator-allow-set-load;
};
pm6125_l6: l6 {
@@ -246,7 +247,8 @@ pm6125_l21: l21 {
pm6125_l22: l22 {
regulator-min-microvolt = <2704000>;
- regulator-max-microvolt = <3544000>;
+ regulator-max-microvolt = <2960000>;
+ regulator-allow-set-load;
};
pm6125_l23: l23 {
@@ -305,6 +307,33 @@ pmr735a_l7: l7 {
};
};
+&sdc2_off_state {
+ sd-cd-pins {
+ pins = "gpio94";
+ function = "gpio";
+ drive-strength = <2>;
+ bias-disable;
+ };
+};
+
+&sdc2_on_state {
+ sd-cd-pins {
+ pins = "gpio94";
+ function = "gpio";
+ drive-strength = <2>;
+ bias-pull-up;
+ };
+};
+
+&sdhc_2 {
+ status = "okay";
+
+ vmmc-supply = <&pm6125_l22>;
+ vqmmc-supply = <&pm6125_l5>;
+
+ cd-gpios = <&tlmm 94 GPIO_ACTIVE_HIGH>;
+};
+
&tlmm {
gpio-reserved-ranges = <13 4>;
Set SDHCI VMMC/VQMMC to <=2v96 and allow load setting by the SDHCI driver, as required by this use case. Configure the SD Card Detect pin, enable the SDHCI2 controller and assign it the aforementioned regulators. Signed-off-by: Konrad Dybcio <konrad.dybcio@linaro.org> --- No changes in v3. Changes in v2: - remove stray newline - pick up r-b .../qcom/sm6375-sony-xperia-murray-pdx225.dts | 33 +++++++++++++++++-- 1 file changed, 31 insertions(+), 2 deletions(-)