@@ -607,17 +607,6 @@ static const struct qmp_phy_init_tbl qmp_v4_dp_tx_tbl[] = {
};
-/* list of regulators */
-struct qmp_regulator_data {
- const char *name;
- unsigned int enable_load;
-};
-
-static struct qmp_regulator_data qmp_phy_vreg_l[] = {
- { .name = "vdda-phy", .enable_load = 21800 },
- { .name = "vdda-pll", .enable_load = 36000 },
-};
-
struct qmp_phy;
/* struct qmp_phy_cfg - per-PHY initialization config */
@@ -662,7 +651,7 @@ struct qmp_phy_cfg {
const char * const *reset_list;
int num_resets;
/* regulators to be requested */
- const struct qmp_regulator_data *vreg_list;
+ const char * const *vreg_list;
int num_vregs;
/* array of registers with different offsets */
@@ -831,6 +820,11 @@ static const char * const sc7180_usb3phy_reset_l[] = {
"phy",
};
+/* list of regulators */
+static const char * const qmp_phy_vreg_l[] = {
+ "vdda-phy", "vdda-pll",
+};
+
static const struct qmp_phy_cfg sc7180_usb3phy_cfg = {
.type = PHY_TYPE_USB3,
.nlanes = 1,
@@ -1992,32 +1986,16 @@ static int qcom_qmp_phy_combo_vreg_init(struct device *dev, const struct qmp_phy
{
struct qcom_qmp *qmp = dev_get_drvdata(dev);
int num = cfg->num_vregs;
- int ret, i;
+ int i;
qmp->vregs = devm_kcalloc(dev, num, sizeof(*qmp->vregs), GFP_KERNEL);
if (!qmp->vregs)
return -ENOMEM;
for (i = 0; i < num; i++)
- qmp->vregs[i].supply = cfg->vreg_list[i].name;
+ qmp->vregs[i].supply = cfg->vreg_list[i];
- ret = devm_regulator_bulk_get(dev, num, qmp->vregs);
- if (ret) {
- dev_err(dev, "failed at devm_regulator_bulk_get\n");
- return ret;
- }
-
- for (i = 0; i < num; i++) {
- ret = regulator_set_load(qmp->vregs[i].consumer,
- cfg->vreg_list[i].enable_load);
- if (ret) {
- dev_err(dev, "failed to set load at %s\n",
- qmp->vregs[i].supply);
- return ret;
- }
- }
-
- return 0;
+ return devm_regulator_bulk_get(dev, num, qmp->vregs);
}
static int qcom_qmp_phy_combo_reset_init(struct device *dev, const struct qmp_phy_cfg *cfg)
Drivers should not be specifying active-mode regulator loads unless supporting an idle mode where the load is reduced during runtime. This effectively reverts commit 85936d4f3815 ("phy: qcom-qmp: add regulator_set_load to dp phy"). Link: https://lore.kernel.org/r/YuPps+cvVAMugWmy@sirena.org.uk Signed-off-by: Johan Hovold <johan+linaro@kernel.org> --- drivers/phy/qualcomm/phy-qcom-qmp-combo.c | 40 +++++------------------ 1 file changed, 9 insertions(+), 31 deletions(-)