mbox series

[RESEND,v1,0/2] Close UART port if NON_PERSISTENT_SETUP is set

Message ID 1599733843-20311-1-git-send-email-gubbaven@codeaurora.org
Headers show
Series Close UART port if NON_PERSISTENT_SETUP is set | expand

Message

Venkata Lakshmi Narayana Gubba Sept. 10, 2020, 10:30 a.m. UTC 
When HCI_QUIRK_NON_PERSISTENT_SETUP is set by drivers,
it indicates that BT SoC will be completely powered OFF
during BT OFF. On next BT ON firmware must be downloaded
again. Holding UART port open during BT OFF is draining
the battery. Now during BT OFF, UART port is closed if
qurik HCI_QUIRK_NON_PERSISTENT_SETUP is set by clearing
HCI_UART_PROTO_READY proto flag. On next BT ON, UART
port is opened if HCI_UART_PROTO_READY proto flag is cleared.

Venkata Lakshmi Narayana Gubba (2):
  Bluetooth: hci_serdev: Close UART port if NON_PERSISTENT_SETUP is set
  Bluetooth: hci_qca: Remove duplicate power off in proto close

 drivers/bluetooth/hci_qca.c    |  5 ++---
 drivers/bluetooth/hci_serdev.c | 36 +++++++++++++++++++++++++++++++++---
 2 files changed, 35 insertions(+), 6 deletions(-)