@@ -74,8 +74,6 @@ static inline void arch_acpi_set_pdc_bit
buf[2] |= ACPI_PDC_EST_CAPABILITY_SMP;
}
-#define acpi_unlazy_tlb(x)
-
#ifdef CONFIG_ACPI_NUMA
extern cpumask_t early_cpu_possible_map;
#define for_each_possible_early_cpu(cpu) \
@@ -159,8 +159,6 @@ static inline u64 x86_default_get_root_p
extern int x86_acpi_numa_init(void);
#endif /* CONFIG_ACPI_NUMA */
-#define acpi_unlazy_tlb(x) leave_mm(x)
-
#ifdef CONFIG_ACPI_APEI
static inline pgprot_t arch_apei_get_mem_attribute(phys_addr_t addr)
{
@@ -565,8 +565,6 @@ static DEFINE_RAW_SPINLOCK(c3_lock);
static void acpi_idle_enter_bm(struct acpi_processor *pr,
struct acpi_processor_cx *cx)
{
- acpi_unlazy_tlb(smp_processor_id());
-
/*
* disable bus master
* bm_check implies we need ARB_DIS
@@ -666,6 +664,7 @@ static int acpi_processor_setup_cpuidle_
max_cstate = 1;
for (i = 1; i < ACPI_PROCESSOR_MAX_POWER && i <= max_cstate; i++) {
+ state = &acpi_idle_driver.states[count];
cx = &pr->power.states[i];
if (!cx->valid)
@@ -673,10 +672,11 @@ static int acpi_processor_setup_cpuidle_
per_cpu(acpi_cstate[count], dev->cpu) = cx;
- if (lapic_timer_needs_broadcast(pr, cx)) {
- state = &acpi_idle_driver.states[count];
+ if (lapic_timer_needs_broadcast(pr, cx))
state->flags |= CPUIDLE_FLAG_TIMER_STOP;
- }
+
+ if (cx->type == ACPI_STATE_C3)
+ state->flags |= CPUIDLE_FLAG_TLB_FLUSHED;
count++;
if (count == CPUIDLE_STATE_MAX)
Make acpi_processor_idle() use the generic TLB flushing code. This again removes RCU usage after rcu_idle_enter(). (XXX make every C3 invalidate TLBs, not just C3-BM) Signed-off-by: Peter Zijlstra (Intel) <peterz@infradead.org> --- arch/ia64/include/asm/acpi.h | 2 -- arch/x86/include/asm/acpi.h | 2 -- drivers/acpi/processor_idle.c | 10 +++++----- 3 files changed, 5 insertions(+), 9 deletions(-)