@@ -1708,6 +1708,30 @@ gpu_leakage: gpu-leakage@21 {
log_leakage: log-leakage@22 {
reg = <0x22 0x1>;
};
+ bigcore_tsadc_trim: bigcore-tsadc-trim@24 {
+ reg = <0x24 0x2>;
+ bits = <0 10>;
+ };
+ litcore_tsadc_trim: litcore-tsadc-trim@26 {
+ reg = <0x26 0x2>;
+ bits = <0 10>;
+ };
+ ddr_tsadc_trim: ddr-tsadc-trim@28 {
+ reg = <0x28 0x2>;
+ bits = <0 10>;
+ };
+ npu_tsadc_trim: npu-tsadc-trim@2a {
+ reg = <0x2a 0x2>;
+ bits = <0 10>;
+ };
+ gpu_tsadc_trim: gpu-tsadc-trim@2c {
+ reg = <0x2c 0x2>;
+ bits = <0 10>;
+ };
+ soc_tsadc_trim: soc-tsadc-trim@64 {
+ reg = <0x64 0x2>;
+ bits = <0 10>;
+ };
};
gic: interrupt-controller@2a701000 {
@@ -2119,6 +2143,39 @@ tsadc: tsadc@2ae70000 {
rockchip,hw-tshut-temp = <120000>;
rockchip,hw-tshut-mode = <0>; /* tshut mode 0:CRU 1:GPIO */
rockchip,hw-tshut-polarity = <0>; /* tshut polarity 0:LOW 1:HIGH */
+ #address-cells = <1>;
+ #size-cells = <0>;
+
+ sensor@0 {
+ reg = <0>;
+ nvmem-cells = <&soc_tsadc_trim>;
+ nvmem-cell-names = "trim";
+ };
+ sensor@1 {
+ reg = <1>;
+ nvmem-cells = <&bigcore_tsadc_trim>;
+ nvmem-cell-names = "trim";
+ };
+ sensor@2 {
+ reg = <2>;
+ nvmem-cells = <&litcore_tsadc_trim>;
+ nvmem-cell-names = "trim";
+ };
+ sensor@3 {
+ reg = <3>;
+ nvmem-cells = <&ddr_tsadc_trim>;
+ nvmem-cell-names = "trim";
+ };
+ sensor@4 {
+ reg = <4>;
+ nvmem-cells = <&npu_tsadc_trim>;
+ nvmem-cell-names = "trim";
+ };
+ sensor@5 {
+ reg = <5>;
+ nvmem-cells = <&gpu_tsadc_trim>;
+ nvmem-cell-names = "trim";
+ };
};
i2c9: i2c@2ae80000 {
Thanks to Heiko's work getting OTP working on the RK3576, we can specify the thermal sensor trim values which are stored there now, and with my driver addition to rockchip_thermal, we can make use of these. Add them to the devicetree for the SoC. Signed-off-by: Nicolas Frattaroli <nicolas.frattaroli@collabora.com> --- arch/arm64/boot/dts/rockchip/rk3576.dtsi | 57 ++++++++++++++++++++++++++++++++ 1 file changed, 57 insertions(+)